Installation Manual
50
Operating Instructions
5.
Remove the screws on each end of the bottom
of the lower frame cover.
•
UB-T880: 2 screws,
UB-T880W: 4 screws
(UB-T880 is shown in the following figure as an
example.)
6.
Open the pen tray, remove the screw caps and
the screws, and remove the lower frame cover.
•
Open the pen tray (
1
), and remove the right and
left screw caps (2 locations). Then, remove the
screws, and remove the lower frame cover (
2
).
Notice
•
When removing the screw caps, hold them
with your finger to prevent them from flying
off.
7.
Fasten to the wall.
•
Use 4 screws to attach the fasteners on the
bottom of the board securely to the wall.
Notice
•
Screws (4 count) are not included with the
elite Panaboard. Please purchase screws
with a size of M6, appropriate for your type of
wall.
8.
Attach the lower frame cover.
•
Perform step 6 and step 5 in reverse and attach
the lower frame cover, making sure there is no
unevenness with the front surface.
Notice
•
When mounting on a wall, do not hit or jolt
the elite Panaboard.
•
After mounting, gently apply some weight on
the elite Panaboard to make sure that it is
securely fastened to the wall.
9.
Confirm that the elite Panaboard can operate.
•
See “Confirming the elite Panaboard Operation”
(page 54).
Screw Caps
UB-T880-PJQXC0337YA_mst.book 50 ページ ２０１０年５月３１日 月曜日 午後４時３０分
