![Panasonic DMRE500H - DVD RECORDER DECK Скачать руководство пользователя страница 9](http://html.mh-extra.com/html/panasonic/dmre500h-dvd-recorder-deck/dmre500h-dvd-recorder-deck_operating-instructions-manual_265946009.webp)
9
RQT7751
≥
Decoder here means the device used to decode scrambled broadcasts (Pay TV).
≥
Change the “AV2 Input” and “AV2 Connection” settings in the SETUP menu to match the connected equipment (
page 65) after tuning is
completed (
Viewing video from the decoder on the television while the
unit is stopped, or while recording
If you connected the television to the AV1 terminal and the decoder
to the AV2 terminal on this unit, press [0]
i
[ENTER]. (“DVD”
appears on the unit’s display.)
Press again to cancel. (“TV” appears on the unit’s display.)
≥
If the television is compatible with RGB input, the RGB output
signal from the decoder can also be output from the main unit the
same way.
Enjoy multi-channel surround sound on DVD by connecting an amplifier and speakers. There are two types of connection, digital and analog.
∫
Digital connection
To enjoy multi-channel surround sound on DVD-Video connect an
amplifier with Dolby Digital, DTS and MPEG decoders using an
optical digital audio cable and change the settings in “Digital Audio
Output” (
page 64) after tuning is completed (
≥
You cannot use DTS Digital Surround decoders not suited to
DVD.
≥
Even if using this connection, output will only be from 2 channels
when playing DVD-Audio.
∫
Analog connection
≥
Switch the attenuator on if sound is distorted with this connection.
Connecting a satellite receiver, digital receiver or decoder
P
R
OUT
AV
4
IN
RF IN
RF OUT
COMPONENT
VIDEO OUT
(PROGRESSIVE/
INTERLACE)
P
B
Y
AV1 (TV)
AV2 (DECODER/EXT)
AV OUT
Satellite receiver, digital
receiver or decoder’s rear
panel
21-pin Scart cable
This unit’s
rear panel
Connecting an amplifier or system component
R - AUDIO - L
VIDEO
R - AUDIO - L
VIDEO
OPTICAL
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
AC IN
SUB WOOFER CENTER
AUDIO OU
j
LAN (10/100)
5.1ch
R - SURROUND - L
OPTICAL IN
Optical digital audio cable
Do not bend this cable
sharply.
Insert fully, with this side facing up.
This unit’s rear panel
Amplifier’s rear panel
Do not place the unit on
amplifiers or equipment
that may become hot.
The heat can damage the unit.
R - AUDIO - L
VIDEO S-VIDEO
R - AUDIO - L
VIDEO S-VIDEO
OPTICAL
OUT
AV
4
I
N
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
SUB WOOFER CENTER
R
L
FRONT
AUDIO OUT
j
LAN (10/100)
5.1ch
R - SURROUND - L
FRONT
R L
SURROUND
R L
CENTER
SUB-
WOOFER
Audio
cable
Red White
Red White
Amplifier’s rear panel
To enjoy multi-channel surround sound on DVD-Video and DVD-
Audio connect an amplifier using the AUDIO OUT 5.1ch
terminals and go to the settings on page 16.
To AUDIO OUT 5.1ch
Connect with AUDIO OUT terminals to enjoy
stereo (2 channel) sound.
This unit’s rear panel
9
7551-EN.book 9 ページ 2004年8月26日 木曜日 午後4時34分