Panasonic DMP-UB704, Руководство по эксплуатации

Страница: 35 / 44

- 35 -
Reference
Troubleshooting guide
Before requesting service, please perform the
following checks.
If the problem remains unresolved, consult
your dealer for instructions.
The following do not indicate a problem with
this unit:
– Regular disc rotating sounds.
– Image disturbance during search.
– Image disturbance when replacing 3D discs.
∫
Unit does not respond to remote
control or unit’s buttons.
Touch and hold [
Í
/I] on the main unit for
3 seconds.
– If still unable to turn the unit off, disconnect the
AC mains lead, wait 1 minute, then reconnect
the AC mains lead.
∫
The buttons of the unit do not work.
Touch the buttons with your finger. They may not
work if operated with your fingernails or hands
wearing gloves.
∫ The buttons of the unit are sensitive.
The buttons of the unit respond to light touch. Do
not place objects on or around them.
∫
Cannot eject disc.
1
While the unit is off
Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– “00 RET” is displayed on the unit’s display.
2
Press [
1
] (right) repeatedly on the remote
control until “06 FTO” is displayed on the
unit’s display.
3
Press [OK].
To return to the factory default.
¾ Select “Yes” in “Default Settings” in the Setup
menu. (
> 34)
To return all settings to the factory preset.
¾ Reset the unit as follows:
1
While the unit is off
Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– “00 RET” is displayed on the unit’s display.
2
Press [ 1 ] (right) repeatedly on the remote
control until “08 FIN” is displayed on the unit’s
display.
3
Press and hold [OK] for more than 5 seconds.
This unit is turned off when the input for the
TV is switched.
¾ This is a normal phenomenon when using
VIERA Link. For details please read the
operating instructions for the TV.
The remote control doesn’t work properly.
¾ Change the batteries in the remote control.
(
>
5)
¾ The remote control and this unit are using
different codes.
If “SET CODE
 ” is displayed on the unit’s
display when a button is pressed on the
remote control, change the code on the
remote control.
Press and hold [OK] and the displayed
number (“
 ”) for more than 5 seconds.
This unit is turned off automatically.
¾ To save on electricity, this unit is turned off
automatically depending on the media if there
is no button operation for about 20 minutes
when not playing back (such as when paused
or displaying the menu, displaying still
pictures, etc.).
Do you have the latest firmware installed?
Panasonic is constantly improving the unit’s
firmware to ensure that our customers are
enjoying the latest technology. (
> 18)
General operation
DMP-UB704_EG-TQBS0021_eng.book 35 ページ ２０１６年８月３０日 火曜日 午前１１時８分