17. Materials
519
Monitor/Viewfinder
0
Do not push hard on the monitor.
This may cause irregular coloration or malfunction.
0
Extremely high precision technology is employed to produce the monitor/viewfinder
screen. However there may be some dark or bright spots, or spots that light
constantly (red, blue, or green) on the screen.
This is not a malfunction.
Though the monitor/viewfinder screen parts are produced with highly controlled
precision technology, some pixels may be inactive or always lit.
The spots will not be recorded on images on a card.
Lens
0
When using this lens, take care not to drop, bump, or apply undue force to it.
Doing so may cause malfunction or damage to this lens and the digital
camera.
0
Do not aim the lens at the sun or strong light sources.
The concentrated light may cause fire or damage.
0
Images may be affected by dust, dirt, and soiling (water, oil, fingerprints, etc.) on the
lens surface.
Before and after recording, use a blower to blow off dust and dirt from the surface of
the lens, then lightly wipe with a soft dry cloth to remove soiling.
0
When the camera is not being used, attach the lens cap and lens rear cap to prevent
dust and dirt from adhering to or entering the camera.
0
To protect the lens contact points
A
, do not do the
following.
These may cause a malfunction.
– Touch the lens contact points.
– Soil the lens contact points.
– Place the lens with its mount surface facing
down.
0
To improve the dust and splash resistant
performance of the interchangeable lens
(S-R2060), a lens mount rubber is used in the mount.
– The lens mount rubber will leave scuff marks on the digital camera mount, but this
does not impact performance.
– To replace the lens mount rubber, contact Panasonic.
Содержание DC-S5
Страница 1: ...Owner s Manual Digital Camera DC S5 DVQP2197ZA F0920MR0 until 2020 09 01 ...
Страница 570: ......
