ー
95
ー
Operating Instructions
Intelligent Controller
98
Settings for energy saving
Energy saving
Item
Explanation
Mode
Set the operating mode to fan. Set either [Fan] or [----]*.
Set T
.
Set the temperature with
and
.
Set “±1” or “±2”, at 1
°
C steps between 16
°C
and 28
°C*.
Fan
Use
to set the fan speed.
Set “Auto”, “High”, “Mid.”, or “Low”*.
I/D unit cyclic Valid
The indoor unit cycling control function is enabled for the selected indoor unit if you put a check mark here.
* When left blank, that item does not cause any operation.
5
Touch [Register].
z
The “Setting” dialogue closes.
z
To cancel the settings, touch [Cancel].
5
6
Set other indoor units.
z
Repeat steps
3 to 5.
7
Touch [T
imer set.].
z
The “T
erm setting” dialogue is displayed.
7
8
Touch the number
.
z
You can set 4
dif
ferent time slots.
8
9
Set the times.
z
The time on the left is the control start time.
The time on
the right is the control end time.
z
Use
to set the time. Hours can be set in the
range
0 to 23, and minutes may be either “00” or “30”.
9
10
Set the control interval.
z
Select “3
min.”, “4
min.”, or “5
min.”.
z
Repeat steps
7 to 9 to set for numbers [1] to [4].
10
Continued on next page
Control operation at regular intervals [I/D unit cyclic]
99
Settings for energy saving
Energy saving
11
Touch [Register].
z
The “T
erm setting” dialogue closes.
z
To cancel the settings, touch [Cancel].
11
12
Put a check mark in the “V
alid” column.
12
13
Select “Y
es” for “I/D unit cyclic”.
13
14
Touch [Register].
z
To cancel the settings, touch [Cancel].
14
Note
y
Up to 10
control groups can be created.
y
Control groups that have not been set will not be the object of cyclic control.
Control operation at regular intervals [I/D unit cyclic]
TGR-318_ENG.indb 95
2017/04/06 10:43:36