Panasonic CZ-256ESMC3, Технические данные инструкция, Страница: 90 / 179

ー
88
ー
Operating Instructions Intelligent Controller
84
Settings for energy saving Energy saving
5
Touch [Register].
z
The “Setting” dialogue closes.
z
To cancel the settings, touch [Cancel].
5
6
Set other indoor units.
z
Repeat steps
3 to 5.
7
Touch [Register].
z
To cancel the settings, touch [Cancel].
7
The “Set temp. range limit” screen
A:
[Select all]/[Clear all] buttons
[Select all]
Select all indoor units.
[Clear all]
Cancel selection of all indoor units.
B:
Change list order
. The list order changes
each time you touch it.
Display
The display follows the order set in “I/D unit settings” (P
.141).
O/D unit
The display follows the address order of the outdoor unit systems.
Address
The display follows the address order set in “I/D unit settings” (P
.141).
C:
The indoor units with a check mark next to them will be the subject of the changes to the settings.
D:
The temperature range limit setting is enabled for the selected indoor unit if you put a check mark here.
This is linked with the “T
emp
range limit” (“Setting” dialogue) (P
.83) setting.
E:
The “Setting” dialogue is displayed when you touch this.
A
B
D
E
C
Restricting the range of set temperatures [Set temperature range limit]
85
Settings for energy saving Energy saving
Restricting operating capacity according to the time s
lot
[Energy saving timer]/[Efficient operation setting*]
* When using gas heat pump air conditioners
You can specify time slots when you want operation capacity reduced.
When set to the 10:00 to 12:00 and 13:00 to 15:00 time slots, the consumption of electricity/gas is reduced during those time periods.
1
Touch [Energy saving] in “EnergySaving”.
1
2
Touch [Energy saving timer].
z
The “Energy saving timer” screen is displayed.
2
3
Put a check mark in the “Select” column (3-1), and touch [Set.] (3-2).
z
The “Setting” dialogue is displayed.
3-
1
3-
2
4
Change the settings.
Item
Explanation
Start time End time
Set the start and end times for “T
imer 1” and
“T
imer 2”.
Use
to set the time.
The setting ranges are as follows.
y
Hours: 00 to 23 (1
hour intervals)
y
Minutes: 00 to 59 (1
minute intervals)
Note
y
You can make the settings extend over dif
ferent dates. For example: 22:00 to 08:00
Continued on next page
Energy saving
operation
10:00
12:00
15:00
13:00
High
Electricity or gas consumed
Low
Energy saving
operation
TGR-318_ENG.indb 88 2017/04/06 10:43:27