2
Notice
•
Microsoft, Windows, and Windows Vista are either
registered trademarks or trademarks of Microsoft
Corporation in the United States and/or other
countries.
•
ISIS is a registered trademark of EMC Corporation.
•
Adobe and Reader are registered trademarks of
Adobe Systems Incorporated in the United States
and/or other countries.
•
Pentium is a trademark or registered trademark of
Intel Corporation or its subsidiaries in the United
States and other countries.
•
Each company’s name or company product name is
each company’s trademark or registered trademark.
The information given in this Installation Guide is
subject to change without notice.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
•
The user may find the booklet “Something About
Interference” available from FCC local regional offices
helpful.
FCC Warning:
To assure continued FCC emission
limitcompliance, the user must use the recommended
shielded interfacing cable when connecting to a host
computer. Also, any unauthorized changes or
modifications to this equipment would void the user's
authority to operate this device.
FCC Declaration of Conformity
Trade Name: Panasonic
Model Number: KV-S1025C or KV-S1020C
Responsible Party:
Panasonic Corporation of North America
One Panasonic Way
Secaucus, NJ 07094 U.S.A.
Telephone No.: 1-800-726-2797
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This appliance is supplied with a moulded three pin
mains plug for your safety and convenience.
A 5 amp. fuse is fitted in this plug. Should the fuse need
to be replaced, ensure that the replacement fuse has a
rating of 5 amps. and that it is approved by ASTA or BSI
to BS1362. Check for the ASTA mark
or the BSI
mark
on the body of the fuse. And you must refit the
fuse over when the fuse is replaced. If you lose the fuse
cover, the plug must not be used.
Illegal Duplication
It is unlawful to make duplication of certain
documents.
Duplicating certain documents may be illegal in your
country.
Penalties of fines and/or imprisonment may be imposed
on those found guilty. The following are examples of
items that may be illegal to duplicate in your country.
•
Currency
•
Bank notes and checks
•
Bank and government bonds, and securities
•
Passports, licenses, official or private documents,
identification cards, and the like
•
Copyright materials, or trademarks without the
consent of the owner
•
Postage stamps, and other negotiable instruments
This list is not inclusive, and no liability is assumed
for either its completeness or accuracy.
In case of doubt, contact your legal counsel.
Notice:
Install your machine near a supervised area to
prevent illegal duplication from being made.
Federal Communications
Commission Requirements
(For United States only)
Safety Information
(For United Kingdom only)
ASA
ASA
How to replace the fuse:
Open the fuse compartment with
a screwdriver and replace the
fuse.