3.
Setting up Internet Access to the Camera.
By registering with the Viewnetcam.com FREE DynamicDNS service,
you can create a personalized web address at which your camera's live
video can always be found on the Internet. For detailed information,
access
Click [Automatic Setup (Internet Access)].
Sets up the camera to view on the LAN.
Sets up the Internet access to the
camera.
Manually sets up the camera.
Disables IPsec. If disabled, the button is
displayed gray.
Displays the Setup page
(see page 51 of the Operating
Instructions on the CD-ROM).
The Enter Network Password window is displayed. Enter the
user name and password that were set, and click [OK].
When using a router that supports UPnP
™
, check [Enable].
When using a router that does not support UPnP
™
, check
[Disable]. Then click [Next>].
• Check if your router supports UPnP
™
referring to the router's
manual.
• If you select [Disable], skip to step
.
To register with the "Viewnetcam.com FREE DynamicDNS
service", check [Register with Viewnetcam.com] and click
[Next>].
• If you selected [Do not register with Viewnetcam.com], skip to step
.
The Enter Network Password window is displayed. Enter
the user name and password that were set, and click [OK].
The "Viewnetcam.com FREE DynamicDNS service"
website is displayed. Follow the displayed instructions for
registration.
• If the message "Failed to configure the router's Port Forwarding by UPnP" is
displayed, your router may not support UPnP
™
or UPnP
™
is not enabled.
Enable your router's UPnP
™
or set Port Forwarding manually following the
router's manual, and try Automatic Setup again. For more information about
setting up a router, refer to the Panasonic Network Camera support website at
http://panasonic.co.jp/pcc/products/en/netwkcam/
• If the message "Failed to register with Viewnetcam.com." is displayed, con-
firm that the router is connected to the Internet.
When "Setup completed" is displayed, make a note of the
URL and click [To Single Camera page].
• When [Enable] was selected at step
.
• When [Disable] was selected at step
.
Note
• The port number must be specified at the end of the camera URL.
For example
Using port 80:
http://(Cameraname).viewnetcam.com
or
http://IP Address
Using any other port:
http://(Cameraname).viewnetcam.com:Port Number
or
http://IP Address:Port Number
• Make a note of the URL for the camera.
• The URL for the local network access may be different from the one set up on
the previous page. Make a note of the URL here again.
When the Single Camera page is displayed, setup is
complete.
Note
• If the camera cannot be accessed,
see page 9 of Troubleshooting on
the CD-ROM.
• To ensure that the most current
image is displayed, Internet Explorer
should be configured as follows.
This will not have a negative effect
on normal use.
1. While viewing any website, click
[Tools]
→
[Internet Options].
2. In the section "Temporary Internet
Files", click [Settings] and check
[Every visit to the page].
Registration with the "Viewnetcam.com FREE
DynamicDNS service"
Security Warning window on Microsoft Windows XP Service Pack 2
To view a video (Motion JPEG) or to use audio feature, ActiveX Controls must be installed.
Follow the steps below to install ActiveX Controls.
Click the warning displayed above the tabs, and click [Install
ActiveX Control...].
Click [Install].
********
4