Panasonic AW-UE50WP, Руководство по эксплуатации, Страница: 97 / 154

Subnet(IPv4)
Enter the subnet mask.
Factory settings: 244.0.0.0
<NOTE>
• [Address (IPv4)] and [Subnet (IPv4)] clarify the multicast address
ranges randomly set during multicast transmissions.
• When [Address (IPv4)] is set to [239.255.0.0] and [Subnet (IPv4)]
is set to [255.255.0.0], the selection is made randomly in the range
between [239.255.0.0] and [239.255.255.255].
• To use the IP address set in [Address (IPv4)], set [Subnet (IPv4)]
to [255.255.255.255].
TTL/HOP Limit
The same as the H.264 [Multicast TTL/HOPLimit] (→ page 92).
Group [Enable, Disable]
Sets whether to use the grouping function when performing NDI
transmission.
Factory settings: Disable
Name
Sets the group name for use when the grouping function is used.
Maximum number
of characters
1 to 63 characters
Characters that
can be entered
Alphanumeric characters
Use discovery server
Sets whether to use the discovery server when performing NDI
transmission.
Server address(IPv4)
Sets the IPv4 address of the server when using the discovery
server.
Streaming format
Make settings for H.264 images used for NDI|HX V2 transmission.
Confirm the settings with the [Set] button.
Refer to the description of H.264 (→ page 91) for information about
[Image capture size], [Frame rate], and [Max bit rate(per client)].
„ „
Audio setting screen [Audio]
Configure audio settings.
<NOTE>
• Images and audio are not synchronized. Therefore, images and audio
may be slightly out of sync.
• The audio may skip depending on the network environment.
„ z
Setting status
Audio
Audio
The setting status of audio input is displayed.
Input Type
The setting status of the audio input type is displayed.
Volume Level CH1
Set the volume of audio output (CH1).
This is only enabled when [Audio] is set to [On].
Volume Level CH2
Set the volume of audio output (CH2).
This is only enabled when [Audio] is set to [On].
Plugin Power
The setting status of audio plugin power is displayed.
Audio over IP
Audio transmission
The setting status of audio data IP transmission is displayed.
Audio bit rate
The bit rate setting status for audio data via IP transmission is
displayed.
„ z
Audio
The setting is confirmed with the [Set] button.
Audio [Off, On]
Turn audio input off/on.
Factory settings: Off
Input Type [Mic, Line]
Mic Set the microphone input.
Line Set the line input.
This is only enabled when [Audio] is set to [On].
Factory settings: Line
96 97
Web screen configurations (continued)