Panasonic AVC ULTRA AJ-UPX36OED, Руководство по эксплуатации

Страница: 81 / 210

– 81 –
Chapter 4 Operation — Menu settings
[CH3] Outputs the signal for audio channel 3 as monaural. When [FILE FORMAT] is set to [AVCHD], it will operate in [CH1].
[CH4] Outputs the signal for audio channel 4 as monaural. When [FILE FORMAT] is set to [AVCHD], it will operate in [CH2].
[CH3/4 STEREO] Outputs the signals of the audio channel 3 and the audio channel 4 as stereo. Outputs as monaural from the built-in speaker.
When [FILE FORMAT] is set to [AVCHD], it will operate in [CH1/2 STEREO].
[CH3/4 MIX] Mixes the signals of the audio channel 3 and the audio channel 4 and outputs as monaural. When [FILE FORMAT] is set to
[AVCHD], it will operate in [CH1/2 MIX].
(Factory setting: [CH1/2 STEREO])
[ALARM]
[BATTERY END]
Sets whether to sound the alarm when the remaining battery level is exhausted.
The items that can be set are as follows.
f [HIGH], [MED], [LOW], [OFF]
(Factory setting: [OFF])
[MEDIA END]
Sets whether to sound the alarm when the remaining recording capacity of the memory card is exhausted.
The items that can be set are as follows.
f [HIGH], [MED], [LOW], [OFF]
(Factory setting: [OFF])
[WARNING]
Sets whether to sound the alarm when a system error or warning occurs.
The items that can be set are as follows.
f [HIGH], [MED], [LOW], [OFF]
(Factory setting: [OFF])
[VIDEO OUT/LCD/VF] menu
Configures the settings for the external output, the information to display in the LCD monitor or viewfinder and the output format.
[VIDEO OUT SEL]
Switches the external output destination of the audio file.
[SDI + HDMI]
Outputs from the <SDI OUT> terminal and the <HDMI> terminal.
[AV + HDMI] Outputs from the <AV OUT> terminal and the <HDMI> terminal.
(Factory setting: [SDI + HDMI])
[SDI OUT]
[OUTPUT SW]
Enables/disables the output from the <SDI OUT> terminal.
[ON] Outputs the video.
[OFF] Does not output the video.
(Factory setting: [ON])
[OUT FORMAT]
Selects the signal to output from the <SDI OUT> terminal. The items that can be selected differ depending on the [SYSTEM] menu → [FREQUENCY]/
[FILE FORMAT]/[REC FORMAT] setting.
[1920 × 1080p] Outputs in 1920 × 1080p.
[1920 × 1080i] Outputs in 1920 × 1080i.
[1920 × 1080PsF] Outputs in 1920 × 1080PsF.
[1280 × 720p] Outputs in 1280 × 720p.
[720 × 480i] Outputs in 720 × 480i.
[720 × 576i] Outputs in 720 × 576i.
(Factory setting: [1920 × 1080i])
@ @
NOTE
t For the combinations that can be set, refer to “Format that can be output from the <SDI OUT> terminal” (page 158).
[3G-SDI OUT]
Sets the format of the 3G SDI signal output from the <SDI OUT> terminal. Can be set when the 3G SDI signal is output.
[LEVEL‑A] Selects the LEVEL-A method.
[LEVEL‑B] Selects the LEVEL-B DL method.
(Factory setting: [LEVEL-B])