Panasonic AJ-PX5100G, Руководство по эксплуатации

Страница: 115 / 263

– 115 –
Chapter 4 Shooting — Viewfinder status display
To display the zebra pattern in the video of the monitor output terminal (<SDI OUT2>, <VIDEO OUT>, <HDMI OUT>), set in the main menu → [I/F
SETUP] → [OUTPUT SEL] → [MONITOR OUT ZEBRA].
Focus assist function
The focus assist function enables you to focus the target easily.
Expanded display [EXPAND]
When [EXPAND] is set in the main menu → [CAMERA] → [SW MODE] → [FOCUS ASSIST], if the <USER> button (<USER
MAIN>/<USER1>/<USER2>) to which [ASSIST] is assigned or the <RET> button is pressed, the center of the screen is expanded approx. three times
so that you can easily bring the image into focus.
EXPANDED
f In the expanded display, the status display and zebra pattern disappear, and [EXPANDED] is displayed at the top of the screen.
f The method to cancel the expanded display can be selected in the main menu → [CAMERA] → [SW MODE] → [EXPAND MODE].
- [10SEC]: Cancels in 10 seconds.
- [HOLD]: Cancels when the button to which [ASSIST] is assigned is pressed.
- [UNTIL REC]: Cancels when recording starts. Expanded display is not available during recording.
@ @
NOTE
t Viewfinder screen and LCD monitor screen are expanded.
t Expanded display is unavailable in the video output, SDI output, and HDMI output.
Focus in red display [IN RED]
When [IN RED] is set in the main menu → [CAMERA] → [SW MODE] → [FOCUS ASSIST], if the <USER> button (<USER MAIN>/<USER1>/<USER2>)
to which [ASSIST] is assigned or the <RET> button is pressed, red borders appear around the contours of the image displayed in the viewfinder or the
LCD monitor.
Make adjustment so that the contours of the subject you want to focus on turn red.
Focus bar display [FOCUS BAR]
The focus bar can be displayed when [ON] is set in the main menu → [VF] → [VF INDICATOR] → [FOCUS BAR].
The degree of focus is indicated by the length of the bar.
Not in focus The bar extends to the right when the viewfinder is in-focus.
Waveform monitor function
A waveform of the video can be displayed by assigning the waveform monitor function to the <USER> buttons (<USER MAIN>/<USER1>/<USER2>)
and pressing the assigned buttons. Press the button again to return to the normal display.
f The waveform and vector displays can be switched by [WFM] (page 172) in the main menu → [CAMERA] → [SW MODE]. Whether to display the
waveform monitor on either or both of the viewfinder and LCD monitor can be selected by [WFM DISP].
f The waveform is not displayed while the focus assist function [EXPAND] is active.
f The waveform display cannot be recorded.