Panasonic AJ-PX380G, Руководство по эксплуатации

Страница: 36 / 229

– 36 –
Chapter 3 Preparation — Mounting and adjusting the lens
Deleting the chromatic aberration compensation file from the camera
Fig. 1
1
Set to [OFF] using main menu → [MAINTENANCE] → [CAC ADJ.] → [CAC CONTROL].
2
In [LIST/DELETE], select the lens part no. you want to delete and press the jog dial button (or the <SET> button). (Fig. 1)
A confirmation screen is displayed.
3
Select [YES], and press the jog dial button (or <SET> button).
The file is deleted.
When the chromatic aberration compensation data is not functioning properly
When the chromatic aberration compensation function is not functioning properly, or when the chromatic aberration compensation data could not be
loaded normally, the viewfinder displays an error message.
Error message Meaning Remedy
[CAC FILE DATA NOT FOUND] There is no chromatic aberration compensation data
matching the connected lens when the chromatic
aberration compensation function is [ON].
This is displayed when the camera is turned on or the
lens cable is connected.
Load chromatic aberration compensation data matching
the connected lens to the camera.
[CAC LENS DATA INVALID] The response data from the lens is not supported, or the
response contains information other than that defined in
the chromatic aberration compensation data.
The lens is not a lens compatible with the chromatic
aberration compensation function.
The chromatic aberration compensation will not function,
but will not cause any problems in use.
[LENS INIT. NOT COMPLETED] Position detection (focus zoom) of the lens is encoder
type, and initialization is not completed.
Turn the focus/zoom ring to pass through the center of
the operating range.
@ @
NOTE
t When mounting lens optical system accessories (converter lens attachments), the chromatic aberration compensation function sometimes does not
function properly since the optical characteristics of the lens change. In this case, set the chromatic aberration compensation function to [OFF].
t When a focus servo is used on CANON lenses, enable recording after initialization is completed in the automatic initialization mode. Data is
sometimes recording while the focus ring is moving.
t When an error message is also not displayed while the chromatic aberration compensation function is not functioning, the software version of the lens
might be old. Contact the manufacturer of the lens you are using.