Panasonic AJ-PX380G, Руководство по эксплуатации

Страница: 190 / 229

– 190 –
Chapter 9 Connecting to External Devices — Connecting the base station (AG-BS300P/AG-BS300E)
Connecting the base station (AG-BS300P/AG-BS300E)
It can be used as an extension system by directly connecting to the base station AG-BS300P/AG-BS300E (optional).
The camera can be controlled by connecting the extension control unit AG-EC4G, the remote control unit AJ-RC10G, or the remote operation panel
AK-HRP200G to the <REMOTE> terminal of AG-BS300.
r Available functions
f Genlock function
f Remote control function
f Return function
f Inter communication (INCOM) function
f TALLY/CALL function
Relay cable
AG-BS300P/AG-BS300E
<SDI OUT1> terminal
<SDI OUT2/IN> terminal
<PHONES> terminal
<AUDIO IN CH1/3> terminal or <AUDIO
IN CH2/4> terminal
INCOM headset (optional)
<CA IN> terminal <CA OUT> terminal
1
Set the main menu → [SYSTEM MODE] → [BS DIRECT MODE] to [ON].
2
Connect the <SDI OUT1> terminal of the camera with the <CA IN> terminal of AG-BS300P/AG-BS300E, and the <SDI OUT2/IN>
terminal of the camera to <CA OUT> terminal of AG-BS300P/AG-BS300E with the BNC cables.
3
To use INCOM, set [INCOM] in the main menu → [OTHER FUNCTIONS] to[ON].
4
Connect the headset to the <PHONES> terminal and the <AUDIO IN CH1/3>terminal, or the <AUDIO IN CH2/4> terminal of the
camera.
Use the relay cable or conversion connector to connect when the terminals of the headset and the camera do not match.
5
Set the headphone level of the headset with the main menu → [OTHER FUNCTIONS] → [INCOM LEVEL] → [PHONE] and the
microphone level of the headset with [MIC].
The headphone level can also be adjusted with the <MONITOR> dial.
@ @
NOTE
t For details, refer to the Operating Instructions of AG-BS300 and AK-HRP200G.
t Set in the construction for serial connection when connecting AK-HRP200G.
t The <SDI OUT2/IN> terminal corresponds to the <BS IN> terminal of AG-CA300G. The <SDI OUT1> terminal corresponds to the <BS OUT> terminal
of AG-CA300G.
t The extension system cannot be used when the main menu → [SYSTEM MODE] → [LINE&FREQ] is set to [1080-59.94P] or [1080-50P].
t Use the BNC cable that is 5C-FW and 100 m or shorter.
t Use an AC Adaptor or battery for the power supply of the camera.
When using the power supply from AG-BS300P/AG-BS300E, connect the camera adapter AG-CA300G (optional) to the camera.
t The microphone used for the INCOM is dynamic microphone only.
t The image may get disrupted when the phase is adjusted with the main menu → [GENLOCK] → [H PHASE COARSE] of AG-BS300P/AG-BS300E.
This is not a malfunction.
t It will automatically restart when the main menu → [SYSTEM MODE] → [BS DIRECT MODE] is switched.