Panasonic AJ-PX270, Руководство по эксплуатации

Страница: 36 / 217

– 36 –
Chapter 3 Preparation — P2 card
P2 card access LED P2 card status Mode check display*
Flashing green slowly
Card full
There is no free space on the P2 card. Reading only is
possible.
[FULL]
Write protect
The write-protect switch on the P2 card is at the Protect
position. Reading only is possible.
[PROTECTED]
Unrecordable card
Recording is not possible by the currently set recording
format since the SD memory card, etc. is inserted. To
record the card, change the recording format or use a
P2 card.
[REC IMPOSSIBLE]
Slot that is not recording
target
The card has been inserted into a different slot from the
slot ([P2] or [microP2]) that was selected in the main
menu → [RECORDING SETUP] → [REC MEDIA].
[FULL]
Off
Card not supported
This card cannot be used on the camera. Replace the
card.
[NOT SUPPORTED]
Illegal format
The P2 card is not properly formatted. Reformat the
card.
[FORMAT ERROR]
No card
The P2 card is not inserted. The card is waiting to be
recognized.
[NO CARD]
Unauthenticated card
This microP2 memory card cannot be authenticated.
Select the main menu → [CLIP] → [AUTHENTICATE],
and enter the password.
For details, refer to “Manual CPS authentication”
(page 122).
[AUTH NG]
* Mode check is displayed on the LCD monitor screen or the viewfinder screen. For details, refer to “Screen status display” (page 154).
P2 card recording time
r
P2 cards supported on the camera
Optional P2 memory cards and microP2 memory cards with a capacity of 4 GB to 64 GB can be used with the camera.
@ @ NOTE
t
AJ-P2C002SG (2 GB) cards cannot be used.
t
When AVC-Intra 200 and AVC-Intra 100 in 1080/59.94P or 1080/50P mode is selected, you cannot record to the following P2 cards.
- P2 memory cards of R, A, or E series
t
The driver installed on the camera may be required to be updated depending on the type of P2 card. (page 207)
t
Refer to our support desk at the following website for the latest information not included in these operating instructions.
http://pro-av.panasonic.net/
r
P2 card recording times
(Example when a 64 GB card is used)
System mode Recording format (codec) Recording time
1080P
AVC-Intra 200 30PN
AVC-Intra 200 25PN
AVC-Intra 100
Approx. 32 min
AVC-LongG 25 Approx. 128 min
AVC-LongG 12 Approx. 240 min
1080i, 720P
AVC-Intra 200 Approx. 32 min
AVC-Intra 100 Approx. 64 min
AVC-Intra 50 Approx. 128 min
AVC-LongG 50 Approx. 128 min
AVC-LongG 25 Approx. 256 min
AVC-LongG 12 Approx. 480 min
DVCPRO HD Approx. 64 min
480i, 576i
DVCPRO50 Approx. 128 min
DVCPRO Approx. 256 min
DV Approx. 256 min
@ @ NOTE
t
The above table shows values for regular recording. With native recording, even longer recording times are available depending on the system mode.
t
In the case of 32 GB P2 cards, the recording time becomes 1/2 of the above recording times, in the case of 16 GB P2 cards, the recording time
becomes 1/4, and in the case of 8 GB P2 cards, the recording time becomes 1/8.
t
Indicated capacities include management and other area, so the space available for recording is less than the values in the table above.