72
Adjustments and Settings for Recording : Selection of video output signals
The unit employs the VIDEO OUT connector and the MON OUT connector as connectors for outputting video signals.
The signal modes for outputting signals from the VIDEO
OUT connector are switched with the VIDEO OUT switch.
HD SDI:
To output the HD SDI signals. When the camera-
recorder is set to the SD mode, SD-SDI signals are
output.
SD SDI:
To output the SD SDI signals. (Signals are down-
converted in HD mode.)
VBS:
To output the composite video signals. (Signals are
down-converted in HD mode.)
The signals output from the MON OUT connector or
VIDEO OUT connector are switched with the OUTPUT
SEL switch.
However, the switching operation is not acknowledged
during the recording operation.
MEM
:
During EE, such as recording, video images taken
by the camera are output. Meanwhile, signals on
the P2 card are output during playback.
CAM
:
The camera images are output at all times.
OFF
:
No signal is output from the VIDEO OUT or MON
OUT connector.
Set the characters to be superimposed on the signals
output from the VIDEO OUT connector by using the
VIDEO OUT CHARACTER switch and the OUTPUT ITEM
item on the menu (<OUTPUT SEL> screen on the
SYSTEM SETTING page).
Selection of video output signals
Settings of signals output from VIDEO OUT connector
VIDEO OUT switch
OUTPUT SEL switch
VIDEO OUT CHARACTER
switch
Item
Variable
range
Remarks
OUTPUT ITEM
MENU
ONLY
TC
STATUS
Set the characters to be
superimposed on the output signals
from the VIDEO OUT connector.
MENU ONLY:
The menu screen is superimposed
only when the menu is accessed.
This normally displays nothing.
TC:
Time codes are superimposed
(when the menu is accessed, the
menu screen is superimposed.)
STATUS:
The characters that are the same
as the characters superimposed in
the viewfinder screen are
superimposed.
(When the menu is accessed, the
menu screen is superimposed.)
#,*2:2836&'DQQMࡍࠫ㧞㧜㧜㧢ᐕ㧝㧞㧝㧞ᣣޓἫᦐᣣޓඦ೨㧥ᤨ㧡㧤ಽ