Panasonic AJ-CX4000G, Руководство по эксплуатации

Страница: 53 / 221

– 53 –
Chapter 3 Preparation — Memory cards
f For microP2 card or SD card
- Press in the microP2 card or SD card further inside and let go.
- Remove the microP2 card or SD card when it comes out from the slot.
@ @
NOTE
t Do not remove the memory card while it is being accessed or while the card access lamp is flashing in orange after it is inserted. Doing so may result
in a malfunction.
t Turn off the power once when the memory card being accessed is removed.
t The clips may become invalid on the memory card that was removed while being accessed. Check the clips and restore them, if required. (page 172)
t The format of the removed memory card cannot be guaranteed when the memory card being formatted is removed. Turn off the power then back on
again, and reformat the memory card.
t If a memory card is inserted into another card slot during playback, the inserted card is not recognized and the card access lamp does not illuminate.
Recognition of the memory card will start after the playback ends.
t In following conditions, the memory card is not immediately recognized even if a memory card is inserted into a vacant card slot during recording:
- Immediately after a pre-recording
- Immediately after switching the recording target card slot
t The card access lamp can be set to off at all time by the [OTHERS] menu → [LED] → [ACCESS LED]. In such case, remove the memory card after
turning off the power or after inserting the card or the operation (recording, playback, etc.) has stopped and sufficient time has passed.
Preventing accidental erasure
To prevent inadvertently erase the recording contents on the memory card, set the write-protected switch on the memory card to the Protect side or the
LOCK side.
Write-protected switch Write-protected switch
@ @
NOTE
t Set the write-protected switch before inserting the card. This will not operated when the write-protected switch is toggled after inserting the card.
Status of the card access lamp and the memory card
Card access lamp Memory card status
Is illuminated green Recording possible Both loading/writing are permitted.
Is illuminated orange Recording target Both loading/writing are permitted. Current recording target.
Flashing orange Accessing card Loading/writing are currently being performed.
Flashing orange rapidly
Recognizing memory card The memory card is being recognized.
Error
An error has occurred.
This will flash even if the memory card is not inserted when an error has
occurred.
Flashing green slowly
No remaining memory card capacity
Memory card has no remaining capacity.
Only loading is possible.
Write-protected
The write-protected switch on the memory card is set to the Protect side or the
LOCK side. Only loading is possible.
Unrecordable memory card
It cannot record with the recording format that is currently set.
Change the recording format or use a memory card compatible with the
recording format.
Card slot that is not recording target
A memory card is inserted into the card slot not selected in the [RECORDING]
menu → [REC MEDIA].
Only loading is possible.
Off
Illegal format The memory card is not properly formatted. Reformat the card.
No memory card inserted A memory card has not been inserted.
Invalid memory card
This is a memory card such as MMC (Multi Media Card) that cannot be used
with the camera.
Setting to the [NETWORK] menu →
[NETWORK FUNC] → [NDI | HX]
Cannot record and play back. The functions other than recording and playback
(loading of the scene file, etc.) can be used.
P2 card formatted with encryption with
CPS password
Cannot be used with the camera. When formatted with the camera, it can be
used as a P2 card that is not encrypted.
During card reader mode The card access lamp is turned off unless accessing.