88
89
Administrator Setup
(continued)
Camera1
Note:
If “Camera1” has not be set for any of Preset1, Preset2, and
Preset 3 on the Video Allocation screen in Administrator
setup, the Camera1 screen cannot be selected.
Page 1
Zoom Limit
Use this function to enter maximum zoom ratio.
Setting :
×22, ×220
AGC Level
Use this function to set the level of camera input gain control.
Setting :
HIGH, OFF, LOW, MID
Init Backlight
Use this function to turn backlight compensation on or off
when the power is on.
Setting :
OFF, ON, LAST
*
1
Init AE Shift
Use this function to adjust brightness when the power is on.
Setting :
0,
-2, -1, +1, +2, LAST
*
1
Flip
Use this function to determine whether to vertically flip
camera video image or not.
Setting :
OFF, ON
AutoZoom Magnification
Use this function to set the target zoom-in ratio.
Setting :
×10, ×15, ×22, ×1, ×2, ×3, ×4, ×5, ×7
AutoZoom Time
Use this function to set the zoom-in pause time.
Setting :
3 s, 5 s, 8 s
AutoZoom End Position
Use this function to set the zoom-end ratio for auto zoom.
Setting:
x1, x2, x3, x4, x5, x7, x10, x15, x22, LAST
*
1
Page 2
Init Camera1 Rec LED
Use this function to turn the [REC] lamp on the camera
connected to the [CAMERA 1] connector on or off when the
power is on.
Setting :
ON, LAST
*
1
,OFF
Init IR Mode
Use this function to set the IR function when the power is on.
Setting :
AUTO
*
2
, OFF, ON, LAST
*
1
IR Level
Use this function to set the IR function level during automatic
switching.
Setting :
LOW, HIGH
IR Time
Use this function to set the IR function detection time during
automatic switching.
Setting :
30 s, 60 s, 300 s, 10 s
Auto Focus
Selects color camera focusing method when,
[Init LPR Mode] is set to “DISABLE”.
[Init LPR Mode] is set to “ENABLE” and [LPR Mode] is set
to “PATROL”.
A recording trigger starts recording when [Init LPR Mode]
is set to “ENABLE” and [LPR Mode] is set to “LPR”.
PRESET :
When the zoom is 3x or below, the camera is
focused at about 15 m (50 feet). Subsequent
zooming will engage auto focus.
DISABLE :
Focus is locked at about 40 m (130 feet) and
auto focus is not available.
AUTO
:
Auto focus goes into operation when the
zoom ratio is changed.
Init LPR Mode
Enables or disables the LPR function (license plate
recognition) when the recorder is turned on.
DISABLE :
Color camera shutter speed changes to
“AUTO”. The zoom position for the camera at
power on returns to the position it had when
the power was last turned off.
ENABLE :
Allows changes to be made to the officer
[LPR Mode]. Values set in this mode will
persist through a power off and become
available at the next power on.
•
•
•
*
1 Applies the setting in effect when power was last turned off.
Unless power is turned off properly, the operating state may not
be saved correctly.
*
2 Automatically switches between ON and OFF.
