Panametrics Sentinel LCT, Руководство пользователя

Страница: 74 / 248

Chapter 4. Advanced Programming
62 Sentinel LNG User’s Manual
4.4 Entering the Meter Correction (K) Factor (cont.)
d. For each row, the screen displays the Reynolds Correction number (
X
) and the Kinematic Viscosity (
K Fact
). If
you wish to change either value, scroll to the value and press [ENT]. Use the arrow keys to change the value
(available in Soundspeeds and Pipe Size Data, document #914-004), and press [ENT].
e. Repeat steps
c
and
d
until all available data (from 2 to 20 rows) has been programmed.
f. Press [ESC] to return to the PROG menu, or continue pressing [ESC] until the display screen reappears.
g. To confirm changes to the table, from the
Unit Menu
, select
Reset Table...
and press
Enter
. To reset the table select
Yes
and press
Enter
. To not reset the table, select
No
and press
Enter
.
4.5 Entering Pipe Parameters
In the
Pipe
submenu, preprogrammed or special pipe parameters can be specified. While following the programming
instructions, refer to Figure 231 on page 212. Remember to record all programmed data in Appendix C, Data Records.
Note: From the PROG menu, proceed directly to Step 4. If a different option is desired, scroll to that option, and
press [ENT] twice to select it (once to enter and again to confirm the selection).
To access the
Pipe
submenu:
1. Press [ESC]. The
Sentinel LNG
enters the
User Program
.
2. Press the [

] key until PROG is bracketed and press [ENT].
3. Use the [

] and [

] keys to scroll to
Composite
and press [ENT].
4. Scroll to the
Pipe
submenu and press [ENT].