Panametrics PT878GC, Инструкция по эксплуатации

Страница: 74 / 224

Chapter 4.
64 TransPort™ PT878GC User’s Manual
4.1.10 Entering the Analog Output
The Analog Output option enables you to enter information to set up output parameters. To enter the option, scroll to
the Analog Output entry on the Program Menu and press [ENTER] . The screen appears similar to Figure 61 below. To
step through each parameter, press the [

] key. Refer to Figure A-6 on page A-6 of Appendix A, Menu Maps.
Figure 61: The Analog Output Window
1. The first prompt enables you to select a range to send a current signal to a recording device.
a.
Press
[ENTER]
to open the drop-down menu.
b. Scroll to the desired output from three choices: Off,
0-20 mA, and 4-20 mA.
c. Press [ENTER] to confirm your selection.
Note: If you select “Off,” you cannot access any other parameters in this option.
2. The next prompt asks you to select the analog output type from a number of choices, as shown in Figure 62
below.
Figure 62: Data Source Selection Window
Analog Output
Cancel OK
Function
Data Source
Zero
On Error
0-20 mA
Velocity
Span
Hold Last Value

m/s
25.5
Select Measurement
Cancel
OK
Diagnostics
Aux Input A
Volume
No Unit
Velocity
UserFunction
m/s
Pressure
Temperature
Aux Input B
Skan/Measure
Mass Flow