Panametrics DigitalFlow XGF868i, Руководство для стартапов, Страница: 37 / 90

DigitalFlow™ XGF868i Startup Guide 27
Chapter 2. Initial Setup
2.3 The XGF868i Keypad (cont.)
When you power up the XGF868i, the display first shows the model and software version:
The meter then starts to display measured parameters.
To enter the Keypad Program , press the [Escape] key, followed by the [Enter] key, and the [Escape] key again. Each
successive key must be entered within 10 seconds of the prior key.
As a guide in following the programming instructions in this chapter, the relevant portions of the Model XGF868i
menu map have been reproduced in Figure 11 on page 37. Proceed to the following sections to enter data in the
Channel
or
GLOBL
menus.
IMPORTANT: If the keypad has not been pressed for 10 minutes, the XGF868i exits the Keypad Program and returns to
displaying measurements. The meter retains any configuration changes that were confirmed with the
[Enter]
key, and restarts as if the operator had completed the programming cycle.
Panametrics
XGF868i Y4DF.STD
CH1 VEL E1
10.00 Ft/s