Panametrics DewPro MMR30, Руководство по установке и эксплуатации

Страница: 13 / 45

DewPro® MMR30 Installation & Operation Manual 5
Chapter 2. Installation Guidelines
Chapter 2. Installation Guidelines
2.1 General Hints
CAUTION!
Before installation, please read all instructions. The DewPro is designed to be mounted
in pressurized systems. Take the necessary precautions when mounting or removing
the DewPro.
• Mount the DewPro
®
vertically whenever possible to prevent particles or condensation from entering the bypass.
• Mount the DewPro
®
after a shutoff valve to depressurize it for removal from the process pipe in case of
maintenance.
CAUTION!
Do not over-tighten! The outlet fitting is connected to the bypass block with a G 1/4
straight thread (with gasket) which will seal if the fitting is simply hand-tightened.
When connecting an external device, counter the fitting with a second wrench when
tightening. If the inlet is equipped with a G 1/2 straight thread and gasket, the seal is
obtained by simply hand-tightening the DewPro
®
.
CAUTION!
If you are installing the DewPro into a pressurized system (up to 10 bar), depressurize
the system before installing or removing the sensor. Pressurized systems require a
stainless steel compression fitting.