Paloma PH-203EWH, Руководство пользователя и инструкции по установке

Страница: 9 / 56

9
TEMPERATURE CONTROL
CONTROLLERS
The water heater can be installed with controllers to enable the user to control the temperature of the
delivered water from the outlet of the water heater.
Deluxe Controllers
There are three types of deluxe controller. They are the Kitchen Deluxe controller Bathroom1 Deluxe
controller and the Bathroom2 Deluxe controller
The Deluxe controllers are identified by a ‘K’ (Kitchen Deluxe controller), ‘B1’ (Bathroom1 Deluxe controller) or
‘B2’ (Bathroom2 Deluxe controller), located under the front panel, to the bottom left hand corner adjacent to
the BATH FILL VOLUME label.
The Deluxe controllers offer additional functions. These are:

An assistance call function, which provides a voice prompt when pressed and will sound on all
controllers.
This is useful should a family member require assistance when in the bathroom.

A Bath Fill mode, which is designed to allow the water heater to deliver a selected volume of water at a
selected temperature.
Bath filling takes pl ace when the hot tap is opened. When the set volume has been delivered, the water
flow from the water heater ceases. Refer to “Bath Fill Mode” on
page 19.
Note: The bath level should be monitored periodically while this function is in use to avoid the possibility
of the bath overflowing. The Bath Fill mode should also be used with caution until you are familiar with its
operation.
Warning: Baths should not be left unattended whenever young children are present.
Warning: Temperature controllers must not be fitted to this water heater as part of a solar water heater
system or if water heater has been installed to an existing water heater installation with solar connected then
all controllers
must be disconnected and removed.
Notes:

Where more than one controller is installed, the second or third controller must be of the same family.

One, two or three controllers can be installed. Only one of each type of controller can be connected to the
water heater. Therefore, a maximum of three controllers only can be connected to each water heater.

A Bathroom 2 controller can only be installed if a Bathroom1 controller is installed and a Bathroom 2
Deluxe controller can only be installed if a Bathroom1 Deluxe controller is installed.

Other
manufacturers’ controllers are not suitable to and cannot be installed with this water heater.