Paloma PH-203EWH, Руководство пользователя и инструкции по установке

Страница: 41 / 56

41
INSTALLATION – CONTROLLERS
CONTROLLERS
The water heater can be installed with controllers to enable the user to control the temperature of the
delivered water from the outlet of the water heater.
Deluxe Controllers
There are three types of Deluxe controller. They are the Kitchen Deluxe controller Bathroom1 Deluxe
controller and the Bathroom2 Deluxe controller.
The Deluxe controllers are identified by a ‘K’ (Kitchen Deluxe controller), ‘B1’ (Bathroom1 Deluxe controller) or
‘B2’ (Bathroom2 Deluxe controller), located under the front panel, to the bottom left hand corner adjacent to
the BATH FILL VOLUME label.
The Deluxe controllers are designed to be hard wired into the water heater using either the Kitchen controller
cable or the Bathroom controller cable
Notes:

Where more than one controller is installed, the second or third controller must be of the same family.

One, two or three controllers can be installed. Only one of each type of controller can be connected to the
water heater. Therefore, a maximum of three controllers only can be connected to each water heater.

A Bathroom2 controller can only be installed if a Bathroom1 controller is installed and a Bathroom2 Deluxe
controller can only be installed if a Bathroom1 Deluxe controller is installed.

An additional Kitchen controller cable or Bathroom controller cable can be used if an extension of the
cable length is required. It will be necessary to cut an opposite end off both cables to be installed in order
to wire them together. Alternatively, the cables may be extended using two-core flex with a minimum
cross-sectional area of 0.5 mm
2
.

Other
manufacturers’ controllers are not suitable to and cannot be installed with this water heater.
Warning: Temperature controllers must not be fitted to this water heater as part of a solar water heater
system because water at a temperature much higher than the controller setting can be delivered. If a solar
preheater has been installed to an existing water heater installation, then all controllers
must be disconnected
and removed.
Location
– The controllers must be installed in dry, shaded and clean locations.
Do not install the controllers:

Near a heat source, such as a cook top, stove or oven. Heat, steam and smoke will interfere with the
electronic components of the controllers.

In direct sunlight.

In or near a wet area. The controllers are not waterproof. Water may damage the controllers.

Outdoors. The controllers are not weatherproof.