PaloAlto Networks Prisma SD-WAN ION 2000, Справочник по аппаратуре

Страница: 33 / 38

ION 2000 HARDWARE REFERENCE | Install ION 2000
33
©
2021 Palo Alto Networks, Inc.
Set Up the ION 2000 with an Existing Router
The analytic or control mode with an existing router allows you to insert the ION 2000 without modifying
any network settings at the remote office. The ION 2000 utilizes an inline insertion method with fail-to-
wire redundancy to accomplish this. The inline insertion method enables the ION device to inspect or
process traffic by only requiring physical changes to the network while maintaining or enabling additional
redundancy.
While the control mode removes an existing router at a site, it is often simpler and less intrusive to deploy
in the control mode with an existing router. In this scenario, you can unplug or disable the existing router
after all functions are verified.
STEP 1 | Prepare the cabling of the ION 2000 to insert it into your network.
Ensure that internet access via a private WAN connection or direct internet broadband is available at
your site to allow for remote configuration of the ION 2000.
STEP 2 | Mount the ION 2000 in the desired installation location before powering on or making any
network modifications.
STEP 3 | Connect the power cable to the ION device and then plug the device power cable into an AC
power outlet.
STEP 4 |
Power on the ION 2000 device.
When the device is powered on, the power indicator turns green.
STEP 5 | Connect the cables to controller, internet, and LAN or WAN ports.