PaloAlto Networks ION 2000, Справочник по аппаратуре

Страница: 29 / 34

Install ION 2000
STEP 5 | Connect the cables to controller, internet, and LAN or WAN ports.
• Controller Port: Connect the controller port to an ethernet port. The controller port is used
for ION-to-network controller communicaon and monitoring. By default, it is configured as
a DHCP client.
• Internet or WAN or LAN Ports:
• Ports 1 to 3 are used as internet, WAN, or LAN ports. Ports 2 and 3 are DHCP-enabled
by default.
• Ports 4 and 5 are used as WAN or LAN ports. They are pre-configured as bypass pairs
with inline fail-to-wire capability.
STEP 6 | Select any port(s) from ports 1 to 3 to configure as internet ports and plug the internet ports
into a broadband internet source.
• By default, the ports configured for internet are protected by a firewall. They can exist
behind a tradional firewall or NAT device.
• Configure the controller port to an exisng DHCP-enabled LAN with access to the internet
via a private network to enable configuraon of stac internet port values, if the internet
ports require stac IP configuraon.
ION 2000 Hardware Reference 29
©
2021 Palo Alto Networks, Inc.