PaloAlto Networks ION 1200 Series, Справочник по аппаратуре

Страница: 77 / 90

Install ION 1200-S
Install the ION 1200-S on a wall
Install an ION 1200-S on a drywall or plywood wall using the wall-mount kit as described in the
following procedure.
STEP 1 | Mark four locations on the wall that line up with the wall mount holes on the bottom of the
device as shown in the ION 1200-S Wall Mount Template .
Print the Wall Mount Template on a US letter size sheet (8.5" x 11"), in portrait mode,
and scale to actual size to ensure the screw hole markers line up correctly.
Ensure there are no building services (water, gas, or wiring) behind the wall where you
intend to install the device.
Screws and anchors are part of the wall-mount kit which is a separate kit option for
the ION 1200-S.
STEP 2 | Use a #1 Phillips-head screwdriver to install the appropriate screws into each of the four
marked locations:
• Drywall—Press a drywall anchor slightly into the center of a template mark. Then use the
screwdriver to apply pressure while turning the anchor clockwise until the surface of the
anchor is flush with the wall. After the drywall anchor is secure, install a 1.25” anchor screw
into the anchor until the bottom of the screw head protrudes 1/4” (.6cm) from the wall.
Repeat this step for the other three screw locations unless either is located over wood, in
which case, use a .75” wood screw instead of a drywall anchor and screw.
• Plywood wall—Use the screwdriver to insert a .75” wood screw into the center of each
template mark that is located over wood until the bottom of the screw heads protrude
1/4” (.6cm) from the wall.
ION 1200 Hardware Reference 77
©
2022 Palo Alto Networks, Inc.