Palmgren TU 2506, Руководство по эксплуатации

Страница: 56 / 98

Page 56
TU2506
ǀ
TU2807V US
INFORMATION
The spindle bearings are permanently greased. Greasing during the maintenance intervals is
not necessary. Further greasing of the spindle bearings is only necessary in case of de- and
remounting of the spindle bearing.
5.3 Repair
Repairs must be carried out only by qualified technical staff; and must follow the instructions
and guidelines given in this manual. Should technical assistance be required,
contact
C.H.HANSON
Industries at (630) 785-6437.
Company
and
C.H.HANSON
Industries are not liable for, nor do they guarantee against,
damage or operating malfunctions resulting from alteration, abuse, lack of main-
tenance or this product’s use for other than its intended purpose. Failure to read and
follow this
operating manual is not covered.
For repairs only use

Proper and suitable tools,

Parts purchased from
company
, or its authorized agent.
every month
La
th
e
T
U250
6
/
T
U280
7V
Lubricate

Lubricate all oilers with machine oil , do not use a grease
gun or similar greasing equipment. Use the oil bottle in
the delivery volume.

"Operating material“ on page 17
Illustr.5-4: Example, oiler on TU2807V
All 100 and
500
operation
hours
Jaw chuck
Cleaning and
greasing
Approximately every 100 operation hours a cleaning of the
jaw guidance is to be performed, depending on the operating
conditions, a complete cleaning is to be performed about
every 500 operating hours.

Leave the jaw chuck on the machine.

Clean the jaws (do not use compressed air) and then
unscrew them. Thoroughly clean with kerosene or with
benzine.

Relubricate with Molykote TP 42.

Make sure that the jaws are in the correct order.
WARNING!
Unadequate lubricants may reduce the clamping force
by more than 50%
Interval Where? What? How?
Oiler