PALAZZANI TRACK 995717 + 093197, Инструкции по сборке и обслуживанию

Страница: 12 / 17

23 22
Technical specs
Hot supply index in low red color
Cold supply index right, blue color
Limits of use recommended by UNI EN 817 for good functioning
Pressure Min = 1 bar Max = 4 bar
Temperature Max = 65
o
Warning
It is of fundamental importance that the device is installed respecting the
input positions of the water supply, down hot and cold on the right.
It is necessary to execute a very careful flushing of the system to prevent
damage to both the faucet and the technological devices installed.
The supply pipes must be rinsed carefully before installing the mixer, so that
no chips, welding residues or other impurities remain inside the pipes.
A centralised filter would protect the system from impurities contained in
the water.
Before starting up, unscrew the aerator and rinse very well.
In case of supply pressures over 5 bar, we recommend the installation of a
pressure reducer for the proper function of the equipment.
Installations performed differently than indicated do not allow the mixer to
operate properly.
Cartridge maintenance
To perform maintenance or check the cartridge, remember to shut off the
water supply and relieve internal pressures by opening the tap.
Remove the cap, if present, unscrew the grub screw and remove
the handle.
Unscrew the cover ring.
With the right key unscrew the ring that closes the cartridge
Check the cartridge and replace it if damaged.
Proceed in reverse order to remount the handle.
Maintenance external parts
The chrome parts of our faucets must only be cleaned with water and
neutral soap.
Do not use abrasive, acid, basic or ammonia products.
In case of limescale deposit, use specific and non-aggressive products.
1 2 3
4
5
Maintenance of the diverter.
To make maintenance of the diverter.
Loose the screw (4) and take out the water outlet (5) from the body of the
bath faucet.
Unscrew the knob (1).
Unscrew and take out the connection (3) and the diverter (2) using the
right Allen key.
Check any damage to or and diverter, then proceed with replacement if
needed.
Proceed in the opposite way to remount the diverter.
OR/GASKETS diverter:
A - or 2062 code: 99524890 (MIS)
B - or 2050 code: 99525290 (TRACK/YOUNG-INDUSTRIAL JOB-
IDROTECH)
C - or 16x2 code: 99525090 (TRACK/YOUNG-INDUSTRIAL JOB)
D - or 14x2 code: 99524990 (IDROTECH)
D
B
C
A