Palax Active TR/TR, Инструкция по эксплуатации

Страница: 25 / 44

25
Palax D270 Active Translation 1-2017
4. Use of the firewood processor, crosscut operation
4.1. Adjusting the log length

The length of the log is adjusted by shifting the log
length limiter, Fig 4.1 .

Remove the bolt C, and shift the log length limiter
to the desired position on the scale A.
4.1
A
B
C
4.2. During the operation

During the crosscut operation, make sure that the log always is supported on the in-feed deck at
the cutting point.

Exercise caution, always keep your hands away from the saw-blade.

Be especially careful when cutting knotty or crooked trees.

When the log stops for cutting, return the feed lever to its initial position. Before cutting the log,
make sure it is not too twiggy or its form is not such that cutting it might be hazardous or cause
some damage.
Placing the log on the deck

The machine is equipped with a feed roller with hydraulic motor. The toothed roller helps
transfer the log to the length set by means of the log length limiter.

Select the log that you wish to process. Note that the maximum diameter of the log allowed for
the machine is 27 cm. The presence of branches and the shape of the tree may increase the
classified diameter of the trunk. When transferring the log to the machine, be careful not to
endanger or harm the operator or the machine.

The operator must take into account the weight of large logs, and take care to avoid getting
injured while lifting them.

To make the work easier, we recommend using a log-stand with the Palax Active firewood
processor.
WARNING! The trunks must not be loaded on the in-feed deck using a timber crane.
WARNING! Wrongly positioned logs may get turned over on the deck by the cutting force. This
might badly twist the saw-bar, causing it to break.
WARNING! Beware of rotating in-feed roller.