Page 17
Prepared for – all rights reserved. 2017a
Maintenance
Main Box
a.
If dirty, remove the dirt off the surface gel pads with wet cotton and a mild
cleanser. Remove the pads from the unit before cleaning.
Never make the cotton so wet that the excess moisture flows into the
openings of the machine
b.
Do not keep the unit in high or low temperatures or humid area when
storing the unit.
i.
Temperature: below +10 degrees C & above +40 degrees C.
ii.
Relative Humidity: below 30% and above 80%.
iii.
Take out the batteries when not in use for long periods.
Lead Wire
Keep the wire loosely rolled when not in use. Folding may break wire.
Then remove the adhesive gel pads from the main unit and store separately.
Adhesive Gel Pad
a.
when cleaning is necessary, use warm water, under 35 degrees C.
b.
When cleaning the adhesive gel pads, remove the moisture completely by
shaking and air-drying.
c.
Store pads on included plastic holders. Place one pad on each side.
d.
Keep the gel pads stored only on the holder. Otherwise, the adhesive
strength will diminish faster.
e.
The adhesive gel pads (electrodes) should be replaced with the same type
and model.
f.
The related information on the adhesive gel pads (electrodes) is inserted
with the unit.
Acu-Roller, Acu-Slippers, Acu-pen
Clean the accessories by using anti-bacterial hand wipes or rinse under warm water. be
sure to wipe dry. For the Acu-Pen be sure to wipe or rinse the top inside of the pen to
avoid clogging.
Change the Battery
Remove the cover by slightly pushing on it and pulling it down and out. Put the batteries
in securely. They should be facing opposite direction. Replace the cover. Turn on the
on/off level dial and check if the LED lamp lights. If the lamp fails to light, check to see
if the batteries are securely inserted and polarity, (+) and (-), of the batteries are correct.
If the light is lit and goes out or the light is very dim, then the batteries may need to be
replaced.
