INSTALLATION GUIDE
FSLN Series LED Strip Light
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2022 PacLights All Rights Reserved
Page 1 of 2
Need help? (800) 988 -6386 Email: [email protected] Website: www.PacLights.com
PL_INST_FSLN_v0
All models of FSLN are Bluetooth Network Conrol enabled. Remove
the Sensor Cover (Fig. 1). Install the PIR Sensor to the FSLN fi xture by
attaching the Connector to the PIR Sensor and press into place onto the
FSLN fi xture (Fig. 2).
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
•
Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
•
To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
•
For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
FSLN-2D25
FSLN-4D45
FSLN-8D90
Connect the ACL and the ACN from the FSLN Fixture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
FSLN DRIVER
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
WIRING DIAGRAM
INPUT
SENSOR COVER
SAFETY CABLE
FSLN FIXTURE
FIG. 3
FIG. 1
A FSLN fi xture can be de-commissioned from any Network Zone manually
by ‘long pressing’ for 5 seconds the ‘Reset’ Button that is located on the
Bluetooth Driver inside the FSLN fi xture. While holding at Slot Insets on
the Lens Assembly, lift and tilt the Lens Assembly away from the Housing
(Fig. 3). The Safety Cables will hold the Lens Assembly. The ‘Reset’
Button is located at the end of the Bluetooth Driver between the Wire
Connectors (Fig. 4).
RESET / DECOMMISSION
PIR/DAYLIGHT SENSOR (OPTIONAL)
CONNECTOR
PIR SENSOR
FIG. 2
FIG. 4
LENS ASSEMBLY
CONNECTORS
DRIVER
‘RESET’
BUTTON
FSLN HOUSING
SLOT INSETS