INSTALLATION GUIDE
FPNN Series LED Flat Panel
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2022 PacLights All Rights Reserved
Page 1 of 3
Need help? (800) 988 -6386 Email: [email protected] Website: www.PacLights.com
PL_INST_FPNN_v0
A FPNN fi xture can be de-commissioned from any Network Zone
manually by ‘long pressing’ for 5 seconds the ‘Reset’ Button that is located
on the Bluetooth Driver inside the FPNN fi xture Panel. Lift the fi xture
Panel Cover (Fig. 3). The ‘Reset’ Button is located at the end of the
Bluetooth Driver between the Wire Connectors (Fig. 4).
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
•
Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
•
To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
•
For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
FIG. 1
FIG. 2
FPNN - 22D30
FPNN - 24D50
FPNN - 14D30
Connect the ACL and the ACN from the FPNN Fixture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
FPNN DRIVER
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
WIRING DIAGRAM
INPUT
FPNN FIXTURE
FIG. 3
RESET / DECOMMISSION
PIR/DAYLIGHT SENSOR (OPTIONAL)
All models of FPNN are Bluetooth Network Conrol enabled. Remove
the Sensor Cover (Fig. 1). Install the PIR Sensor to the FPNN fi xture by
attaching the Connector to the PIR Sensor and press into place on the
FPNN fi xture (Fig. 2).
FIG. 4
SENSOR COVER
CONNECTOR
CONNECTORS
FPNN FIXTURE
‘RESET’
BUTTON
DRIVER
PANEL
COVER
FPNN FIXTURE
PIR SENSOR
