46
Packard Bell oneTwo L5860 / L5861 AIO Computer Service Guide
Removing the Memory Modules
1.
Remove the wall mount plate by following the procedure described on page 36.
2.
Open the holding clips securing the memory modules (
a
), then remove the memory modules from the
DIMM slots (
b
).
Removing the Power Supply Unit
1.
Remove the wall mount plate by following the procedure described on page 36.
2.
Disconnect the 4-pin and 24-pin ATX power cables from their mainboard connectors.
a.
Press the top portion of the cable’s retaining latch
b.
Pull the cable straight up from its connector.
IMPORTANT
When installing a processor:
• Note the golden arrow on the corner to make sure the processor is properly oriented over
the socket.
• Moisten a soft cloth with isopropyl alcohol and clean the processor die to remove any
thermal grease residue. Wipe the die surface several times to make sure that no particles
or dust contaminants are evident. Allow the alcohol to evaporate before continuing. Apply
just enough thermal grease to evenly coat the surface of the processor die.
Содержание oneTwo L5860
Страница 6: ...vi Packard Bell oneTwo L5860 L5861 AIO Computer Service Guide ...
Страница 70: ...62 Packard Bell oneTwo L5860 L5861 AIO Computer Service Guide ...
Страница 92: ...84 Packard Bell oneTwo L5860 L5861 AIO Computer Service Guide c Press Enter to flash the ME firmware ...
Страница 132: ...Packard Bell oneTwo L5860 L5861 AIO Computer Service Guide 124 ...