Packard Bell Daytona, Руководство по разборке

Страница: 10 / 11

9
Fig. 12: Disconnecting the switch/LED assembly cable
4. Gently pull away the cable and the switch/LED assembly from the chassis.
Note: When reassembling the switch/LED assembly, take care that you return it to
its original position, i.e. with the switch at the top and the LEDs at the bottom.
Removing the Power Supply
To remove the power supply unit, first remove the front bezel (see section Removing the
Front Bezel ) and remove the side cover (see section Removing the Left Side Cover ); then
follow the steps below:
1. Place the chassis on its side, with the motherboard at the bottom.
2. Disconnect the power supply cables from all peripherals and the motherboard.
3. Remove the screws that secure the power supply unit to the back of the chassis.
Fig. 13: Removing the power supply unit screws
4. Carefully lift the power supply out of the chassis.
Note: When reassembling the power supply unit, make sure that the voltage
selector switch is set correctly before connecting the system to a power strip (surge
protector) or grounded AC electrical outlet. If the switch is set incorrectly, the system
could become seriously damaged.
Packard Bell Daytona Disassembly Manual