Pacific Power Source UPC-32, Руководство по эксплуатации

Страница: 64 / 128

SECTION 4 OPERATION
54
4.6.1.1 COPY PROGRAM
COPY PROGRAM is used to copy Program data.

From any METER display (V/I, AMPS or POWER), press the fn key to enter SETUP MODE.

From the SETUP display, press 1 to enter PROGRAM SETUP.

From the PROGRAM SETUP display, press 1 to enter COPY PROGRAM.
NOTE: You cannot copy to a program that is currently executing.
COPY PROGRAM: RANGE
SOURCE PROGRAM NUMBER=1 0-103
DESTINATION PROGRAM NUMBER=2 1-99
PRESS STORE TO COPY.
SOURCE PROGRAM NUMBER :
0 will copy the present MANUAL MODE operating parameters.
1-99 are user created programs that may be edited or copied to and from.
Program 100 is a MIL-STD-704D overvoltage transient.
Program 101 is a MIL-STD-704D undervoltage transient.
Program 102 is a MIL-STD-704D over-frequency transient.
Program 103 is a MIL-STD-704D under-frequency transient.
These programs may be copied to any of programs 1 - 99 and executed.
DESTINATION PROGRAM NUMBER :
1-99 are user created programs that may be edited or copied to and from.
4.6.1.2 DELETE PROGRAM
DELETE PROGRAM is used to delete individual programs. This is useful to free up memory.

From any METER display (V/I, AMPS or POWER), press the fn key to enter SETUP MODE.

From the SETUP display, press 1 to enter PROGRAM SETUP.

From the PROGRAM SETUP display, press 2 to enter DELETE PROGRAM.
NOTE: You cannot delete a program that is currently executing.
DELETE PROGRAM: RANGE
PROGRAM TO DELETE=1 1-99
PRESS STORE TO ERASE.
4.6.1.3 INITIALIZE PROGRAMS, WAVEFORMS, SETUP
INITIALIZE PROGRAMS, WAVEFORMS, SETUP will erase all user entered programs and reset Program 1
and all Waveforms and Setup values to their original factory defaults. This is convenient if you want to reset
the UPC to the factory state without affecting the calibration.

From any METER display (V/I, AMPS or POWER), press the fn key to enter SETUP MODE.

From the SETUP display, press 1 to enter PROGRAM SETUP.

From the PROGRAM SETUP display, press 3 .