Pacific Floorcare S-28, Руководство по эксплуатации, Страница: 8 / 60

8
SERVICING - LEAD ACID BATTERIES (NON-HYDROLINK® MODELS)
WARNING: Batteries emit hydrogen and oxygen gas
-
Keep sparks and open flame away. Do not smoke near the machine
- Charge batteries in a well-ventilated area with the battery compartment open
WARNING: Do not wear jewelry when working near moving or electrical components
CAUTION: Always wear protective clothing, gloves and goggles when handling and charging batteries
REQUIRED EQUIPMENT

Eye protection

Acid resistant gloves

Distilled water

Baking soda (neutralizes acid spills)
SAFETY
Never:

Add acid to a battery

Smoke near batteries

Charge a frozen battery

Leave an acid spill unattended

Store batteries unless they are fully charged

Charge a battery when the temperature is above 122°F (50°C)

Charge a flooded battery without securing vent caps on the cells

Place objects on top of batteries, which can cause a short circuit
Always:

Neutralize acid spills with baking soda and water

Use insulated tools and check connections for proper torque
WATERING

If contact with electrolyte (sulfuric acid) occurs, flush with large amounts of water

Use only distilled water (tap water can contain contaminants that will damage the battery)

Remove the caps and place them upside down to check electrolyte levels

For discharged or partially charged batteries, add just enough water to cover the plates

Fully charge the batteries

Add distilled water to a level of 1/8” below the vent well
CLEANING AND INSPECTION

Fluid on the top of a battery may mean it is being over-watered or overcharged

Check cleanliness and keep terminals and connectors free of corrosion

Clean with a solution of 1 cup baking soda to 1 gallon of water

Do not allow cleaning solution to get inside the battery

Rinse with water and dry with a clean cloth

Keep the area around batteries clean and dry

Properly secure all vent caps

Check battery cables and connections. Replace any damaged cables and tighten any loose connections
Add distilled water to a level
of 1/8”below the vent well
Remove the caps and place
them upside down to check
RETURN TO
TABLE OF
CONTENTS