Pacific Floorcare S-28, Руководство по эксплуатации, Страница: 26 / 60

TROUBLESHOOTING GUIDE
26
RETURN TO
TABLE OF
CONTENTS
ISSUE POTENTIAL CAUSE PROPOSED SOLUTION MANUAL SECTION
INSUFFICIENT WATER TO SCRUB HEAD
SOLUTION FLOW SETTING IS TOO LOW ADJUST SOLUTION CONTROL
SOLUTION
DISTRIBUTION
SOLUTION TANK IS EMPTY ADD WATER/SOLUTION TO THE TANK
SOLUTION
DISTRIBUTION
INLINE SOLUTION FILTER IS CLOGGED REMOVE AND CLEAN THE FILTER
SOLUTION
DISTRIBUTION
SOLUTION TUBE IS CLOGGED, KINKED, OR DAMAGED INSPECT TUBES PARTS DIAGRAMS
SOLUTION SHUT OFF VALVE IS CLOSED OPEN VALVE
SOLUTION
DISTRIBUTION
SOLUTION SOLENOID VALVE MAY BE FAULTY VERIFY OPERATION AND REPLACE IF NECESSARY PARTS DIAGRAMS
CHEMICAL INJECTION PUMP IS NOT RUNNING
* ONLY ON MACHINES WITH OPTIONAL CHEMICAL INJECTION
SYSTEM
VERIFY OPERATION AND REPLACE IF NECESSARY PARTS DIAGRAMS
POOR WATER RECOVERY
RECOVERY TANK IS FULL EMPTY RECOVERY TANK RECOVERY SYSTEM
DIRTY OR WORN SQUEEGEE BLADES INSPECT AND ROTATE OR REPLACE AS REQUIRED RECOVERY SYSTEM
RECOVERY HOSE LOOSE OR DAMAGED INSPECT AND REPAIR PARTS DIAGRAMS
RECOVERY HOSE OR SQUEEGEE ASSEMBLY HAS AN
OBSTRUCTION
CLEAR OBSTRUCTIONS FROM RECOVERY SYSTEM PARTS DIAGRAMS
SQUEEGEE ASSEMBLY MAY BE OUT OF ADJUSTMENT ADJUST AS NECESSARY RECOVERY SYSTEM
STUCK OR DAMAGED BALL FLOAT INSPECT AND REPAIR/REPLACE RECOVERY SYSTEM
RECOVERY TANK LID IS NOT SEALING PROPERLY
INSPECT RECOVERY LID GASKET. REPAIR OR REPLACE IF
NEEDED
PARTS DIAGRAMS
DRAIN HOSE CAP IS NOT INSTALLED PROPERLY INSTALL DRAIN HOSE SECURELY RECOVERY SYSTEM
CLOGGED HEPA FILTER
REMOVE AND INSPECT INSIDE AND OUTSIDE OF HEPA
FILTER
PARTS DIAGRAMS
LOW BATTERY VOLTAGE CHARGE BATTERIES CHARGING
MACHINE WILL NOT TURN ON
FAULTY KEY SWITCH DIAGNOSE AND REPLACE WIRING DIAGRAM
DISCHARGED BATTERIES CHARGE BATTERIES CHARGING
LOOSE OR DAMAGED WIRE REPAIR WIRING DIAGRAM
MACHINE NOT CLEANING FLOOR PROPERLY
WORN PAD OR BRUSH INSPECT AND REPLACE AS REQUIRED SCRUB DECK SETUP
WRONG PAD OR BRUSH FOR APPLICATION
CONTACT YOUR LOCAL DISTRIBUTOR FOR RECOMMENDED
APPLICATION
SCRUB DECK SETUP
INSUFFICIENT CLEANING SOLUTION FOR APPLICATION ADJUST THE MIXTURE AS REQUIRED
SOLUTION
DISTRIBUTION
EXCESSIVE FOAM IN RECOVERY TANK
IMPROPER DETERGENT TYPE
USE A LOW-FOAM DETERGENT OR ADD A DEFOAMING
AGENT TO THE RECOVERY TANK. READ ALL CHEMICAL
LABELS THOROUGHLY BEFORE USE
RECOVERY SYSTEM
MIXTURE SETTING TOO HIGH ON OPTIONAL CHEMICAL
INJECTION SYSTEM
ADJUST TO A LOWER RATIO AND/OR FLOW RATE
SOLUTION
DISTRIBUTION
VACUUM MOTOR WILL NOT RUN
SQUEEGEE LIFT LEVER IS STILL RAISED LOWER SQUEEGEE LEVER RECOVERY SYSTEM
VACUUM RELAY MAY BE FAULTY
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND
ISOLATE
WIRING DIAGRAM
VACUUM SWITCH OR WIRING MAY BE FAULTY
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND
ISOLATE
WIRING DIAGRAM