12
Fig. # 18
Fig. # 19
Fig. # 21
Fig. # 20
Embers
Frame Tabs
Latch
Fan Cover
Weld Nuts
Glowing Embers
Note: Use only glowing embers supplied with the
appliance. Use of any other materials or incorrectly
placed embers may cause an incorrect flame pattern,
sooting and/or delayed ignition.
Place 10 to 12 pieces randomly on the front burner area
as shown in figure #20. This will produce the best
results.
Levelling Legs
Levelling legs are provided as a convenient means for
levelling the appliance when it is installed on an irregu-
lar surface. The legs (3" long threaded bolts) are pack-
aged in a separate parts bag inside the appliance. From
the underside, screw the legs into the threaded holes
into the base, near the back of the appliance. Alter-
nately, the burner and fan cover may be removed to
access the weld nuts from inside (Fig. # 18). The legs
thread into the nuts and protrude out the bottom, raising
the rear of the appliance until it is level with the front.
Glass Frame Installation
The glass frame assembly is designed for easy installa-
tion and removal with positioning tabs on top of the
firebox and quick release latches located under the
firebox.
Installation:
1) Grasp the sides of the glass frame assembly and
hook over the frame tabs. Ensure that the tabs on the
top of the unit engage the corresponding slots in the
glass frame.
2) Swing the bottom into position and latch in place
with the over-center latches (Fig. #18).
Removal:
1) Fold down the bottom louver, if installed, to access
the over-center latches. Disengage the latches by
pulling each lever down and forward (Fig. #18).
2) Grasp the sides of the frame and swing the bottom
out to clear. Lift up and then forward to disengage
from top (Fig. #19).
13
Fig. #24
Fig. #23
Fig. #22
Louver Installation
Unpack and inspect all parts. A flathead or a #2 Robertson
screwdriver is required to install the louvers.
1) Fasten top louver to the top casing with the screws
provided (see Fig. #22).
2) Fasten bottom louver to the hinge brackets at the bottom
of the appliance (see Fig. #23).
Optional Radiant Overlay
The optional Radiant Overlay may be installed at any time.
Unpack and inspect all parts. Install Overlay as follows:
1) Remove the glass frame as outlined in "Glass Frame
Removal" section. Place face up on a flat, stable surface to
avoid damage.
2) Remove screws retaining front trim and set trim aside.
3) Position Radiant Overlay over top of frame.
4) Replace trim and screws (Fig. #24).
5) Reinstall complete assembly onto appliance. During in-
stallation ensure that the tabs on the top of the unit engage the
corresponding slots in the glass frame.
f i r e - p a r t s . c o m
