Pacific energy ESPR.BODYB, Инструкция по установке и эксплуатации

Страница: 27 / 40

Pilot
Orifice
Figure 36: Orifice and pilot.
Figure 37: Pilot hood removal.
Venturi
shutter
Figure 38: Venturi shutter.
Propane Conversion
Before starting the conversion make sure to shut off
the gas supply to the unit and allow fireplace to cool
to room temperature.
To convert the gas fireplace from natural gas to propane
the kit is required. This kit comes with new pilot and
burner orifices as well as a new pressure modulator for
the valve.
To switch the pressure modulator, follow the instructions
that are provided with the conversion kit.
To change the orifices you are required to remove
the door, media set, and burner. Please refer to
the appropriate sections of this manual and follow
instructions on how to correctly remove the components.
After removing the burner you will have access to the
burner orifice which is located on the bottom of the
burner tray, as seen in Figure 36. The orifice can be
removed using a ½” socket. Before installing the new
orifice, Thread Sealant needs to be applied to the
threads of the new orifice to ensure a proper seal when
installed.
To replace the pilot orifice you will need to remove the
pilot hood which is held in place by a spring. First
remove the spring, and then remove the hood by pulling
it up from the pilot bracket, seen in Figure 37. To remove
the existing orifice insert a 5/32” or 4mm Allen wrench
into the hexagonal key-way of the orifice and rotate
counter-clockwise until free. Insert the new orifice using
the same Allen wrench and tighten it until a torque of
9 lbf in (1 Nm) is achieved. Replace the pilot hood by
aligning the tab on the base of the hood with the slot in
the side of the pilot journal, and push the hood down
onto the pilot bracket. Replace the spring by pushing it
onto its seat.
Before returning the burner into position, the venturi
shutter will have to be adjusted to the correct opening.
The correct venturi settings are shown in Figure 38.
Loosen the screw and slide the shutter. Tighten the
screw, and return the burner into position.
27 280617-40
5056.201-A
ESPRIT