4 .
Kabel Digital
USING EQUIPMENT SAFELY
Your set-top box has been manufactured to meet
international safety standards, but you must take
care to operate it safely.
It is important that you read these safety
instructions.
WARNING: Remember that contact with AC mains
can be lethal or can cause severe electric shock.
To avoid the risk of electric shock:
Never remove the top cover from your set-
top box as there are high-voltage live parts
inside. There are no user-serviceable parts
inside your set-top box.
Make sure all electrical connections are
properly made.
Do not connect any equipment to the mains
supply until you have properly connected
all the other leads.
Disconnect your set-top box from the mains
supply (by disconnecting its mains lead
from the mains socket on the wall) before
you disconnect any other equipment from
its rear panel.
Never push anything into holes, slots or
other openings in the case (except a
smartcard into the slot provided, and only
when you are requested to do so).
CAUTION:
Do not use or store your set-top box in hot,
cold, damp or dusty places.
Do not block the ventilation holes of your
set-top box. Leave a gap of at least 5cm
above and around it to allow for adequate
ventilation. Never stand it on soft
furnishings.
Do not put anything on your set-top box
which might drip or spill into it. Never stand
objects filled with liquids, such as vases, on
top of your set-top box.
Do not place your set-top box in an
unventilated cabinet or on top of a unit
which emits heat (e.g. a VCR).
Never place naked flame sources, such as
lighted candles, on top of your set-top box.
CONNECTING TO THE MAINS
SUPPLY
●
Your set-top box operates with 230V AC,
50-60 Hz mains supplies.
Do not connect the set-top box to any
supply other than this.
●
The supplied mains lead has a 2-way
connector at one end and a mains plug at
the other. You should always insert the 2-
way connector into your set-top box
before
you insert the plug into the mains supply.
●
The only way to disconnect your set-top box
from the mains is to remove the mains lead.
Your set-top box must therefore be installed
near to the mains socket-outlet, which
should be easily accessible.
●
If you are in any doubt about the mains
lead, its plug or its connection, consult a
competent electrician.
●
Please follow the instructions in the
following sections, which guide you through
connecting and setting it up.
●
See also pages 12 and 13, which describe
your set-top box’s remote control.
IMPORTANT
prem-user-eng-Iss3b.fm Page 4 Wednesday, July 20, 2005 12:20 PM
