!
Caution:
SYSTEM USE PRESSURE AND HIGH TEMPERATURE
!
Caution:
DO NOT POSITION HEAD OR OTHER BODY PARTS OVER THE MOLD WHEN
RAISING THE RAM TO REMOVE THE SPECIMEN MOUNT
!
During operation, the closure and upper parts of the heating and cooling block can get very hot. For
safety, do not touch the closure unit. Use protective gloves if required.
!
Always completely screw tighten the bayonet cover and back off a fraction so it is not too tight.
Improper installation can result in hot molten mounting material leaking (
danger of burning).
!
Initial cooling water coming into contact with mold will produce an initial burst of steam. To avoid
danger of burning
, secure the drain line and use caution when the
TERAPRESS TP-7001
compression mounting press is in use.
!
Mold cylinder and ram get very hot during the mounting process. Take care before changing
(
danger of burning).
!
Mounting samples must be chemically compatible with the mounting material.
Do not mount
flammable samples.
!
Before opening the unit, disconnect main power plug. Replacement parts should be installed only
by qualified personnel.
!
Follow proper operating instructions (See opposite page) and obtain proper training before
operation.
!
Do not leave press unattended during operation.
!
Turn-off external water supply when press is not in operation.
!
If bayonet cover is difficult to remove, verify that the lower ram has been lowered. If bayonet cover
is still hard to remove, do not force. Call for service.
!
If sample does not eject properly or is sticking, discontinue use immediately and call for service.
TERAPRESS TP-7001 Use & Safety
Safety Notes
