INSTALLATION AND OPERATION MANUAL
PAC HEAT RECOVERY WATER HEATER
Page
5
Maximum testing pressure
150
PSI
(10.34
Bar
)
Maximum testing refrigerant
600
PSI
(41.37
Bar
)
Product Content
1.
PAC Heat Recovery Water Heater the components as below.
The three layer of PAC Heat Recovery Water Heater :-
-
Outer :
The outer jacket of PAU model made of stainless steel 304 high resistant
to corrosion and rust. For the PAS model is made of powder coated steel to
protect against corrosion.
-
Middle :
The middle is a special thermal insulation, Poly Urethane. Prolong to
keep the heating and strong.
-
Inner :
The inner pressure tank is made of stainless steel 316L and seamless
Heat exchanger. Resistant to high corrosion, heat and pressure with clean and
safe.
Heat Exchanger equipment.
Made of seamless stainless steel 316L Resistant to
high corrosion
and prevent leakage of refrigerant efficiently.
Cold water inlet : Size 3/4” use for 50L and 75L tank and the size 3/4” use for
100L and 150L tank. The inlet must to connected to a water tank at the minimum
to prevent to mixing the cold water, hot water production.
Hot water outlet :
Size 1/2” use for 50L and 75L tank and the size ¾” use for
100L and 150L tank. The inlet must to connected to a water tank at the top of
efficient storage of heat and hot water temperatures up.
Magnesium Anode
(
Mg. Anode
)
Size ¾” use for sediment trap and scale to
reduce contamination of the water, make a water safer and prevent the equipment
within the tank for more safety.
Electric Heater : It on the button when placing a vertical cylinder. As an option
in case that does not turn on air conditioners for a long time.
Components within the tank made of Stainless Steel 316L it is do not all react the
same positive impact on the cleanliness of hot water and tank. Long-term need to install
control equipment, temperature and pressure that comes with the tank.
To prevent
