SET-UP/ OPERATING INSTRUCTIONS FOR
56IN LED CHRISTMAS LAMP POST
ITEM# 2220-56062
INSTRUCTION MANUAL
WARNING:
This is not a toy. For decoration purposes only. For indoor and outdoor use.
Not intended for use by children under the age of 14. Do not place the product near an open heat
source such as a fire or other heat source, such as a radiator, stove, fireplace, etc.
A
Top Support Pole
B
Lower Support Pole
C
Base
D
Lamp
E
“North Pole” Sign
G
Ground Stakes
H
AC/DC Adapter
F
Christmas Bow
PART LIST:
X 1
X 1
X 1
X 1
X 4
X 1
I
Large Try Me button
X 1
X 1
X 1
1
2
Questions, problems, missing parts?
Before returning to your retailer, send email to our
customer service department, email address is [email protected].
PREPARATION:
Before assembling the lamppost, make sure that all parts are included by comparing the
parts with the package content list in the diagram above. If any of the parts are missing or have been
damaged, do not attempt to assemble and/or operate the lamppost. Contact customer service for
replacement parts.
1
2
3
SET-UP INSTRUCTIONS:
Assembling the Snow-Blowing LED Lamppost. Carefully remove the contents from the box.
Step 1:
Insert the “Power Cord” leading from the DC Power Adapter through the “lower-pole” section, as
shown in Diagram “1”. Once this is completed, the “Lower-Pole” section can be attached to the
“Base” section and secured by twisting it clockwise, which will lock it into place. Once the
“Lower-Pole” section has been locked into place, the “Power Cord” can be inserted into and through
the “Middle Pole” section, which can then be attached to the “Lower-Pole” section and then locked in
place by twisting clockwise, as shown in Diagram “1”. The “Power Connection Plug” located at the
end of the “Power Cord”, can now be plugged into the “Adapter Jack”, located on the bottom of the
Snow-Blowing LED Lamp, as shown in Diagram “1”. The Snow-Blowing LED Lamp can now be
attached to the assembled lamppost and twisted into place by turning the lamp “clockwise”, which
will lock it into place, as shown in Diagram “1”.
Step 2:
Attach the “North Pole” sign into the LED lamp, as shown in Diagram “2”
Step 3:
The included “Christmas Bow” can now be attached to the front of the Lamppost and adjusted to
give it a more festive look. When the Lamppost is fully assembled it can be lifted into place and
secured to the ground by using the 4 Ground Stakes that are included with the Lamppost. The
Ground Stakes should be hammered into the ground in order to give the assembled Lamppost
adequate support. as shown in Diagram “3” The Snow-Blowing LED Lamppost is now fully
assembled and ready for use.
Twist
to lock
Twist
to lock
Twist
to lock
A
D
E
F
B
C
A
B
A
B
A
B
Align parts A and B
at the same place
G
Please make sure
the sign support
rod is fully inserted
into the connector.
Power
Connection
Plug
Removable Try Me
Battery Case
(4 x AAA batteries
included)
TRY
M
E
