P.S.I TireView, Руководство по установке и обслуживанию, Страница: 20 / 35

Section 1 - TireView
™
TPMS Instruction Manual
7. Press and hold the BACK button.
8. Listen for THREE beeps followed by SIX beeps, then release the BACK button. DEL ALL will show on the
TPMS display.
9. Press the SET button one time. The TPMS display will beep and all sensor ID codes will be deleted.
10. Press the BACK button two times to return to the main screen.
Sensor Installation
Installing the Cap Sensor After Code Pairing
CAUTION: DO NOT OVER-TIGHTEN THE CAP SENSOR. DAMAGE CAN OCCUR.
Note: The cap sensors will start to transmit data after they are paired to the TPMS display.
Note: The first time the display is turned on, it can take up to 20 minutes to receive all cap sensor data.
1. Screw the correctly labelled cap sensor onto the tire valve stem.
2. If applicable, install the correctly labeled cap sensor onto the appropriate flow-thru bulkhead located inside
the flow-thru bracket assembly. Go to
TireView
™
TPMS Flow-thru Bracket Assembly
on page 28.
3. Tighten the cap sensor until air stops leaking.
4. Slightly twist the cap sensor to fully seat it.
Install the Internal Sensor
CAUTION: DO NOT PLACE THE TIRE CHANGE SHOVEL ABOVE THE TIRE VALVE STEM. PLACE THE
TIRE CHANGE SHOVEL 5.9 IN. (15 CM) AWAY FROM THE TIRE VALVE STEM. FOLLOW TIRE CHANGE
SHOVEL MANUFACTURER'S INSTRUCTIONS.
1. Remove the wheel from the vehicle and deflate the tire.
2. Use the tire change shovel to demount the tire from the wheel. See
Figure 6
.
3. Make sure the rubber pad has been installed on the sensor. See
Figure 7
.
4. Attach the sensor to the band clamp assembly with the accompanying hardware. See
Figure 7
.
5. Put the sensor and band clamp assembly in the center position of the wheel hub. See
Figure 9
.
6. Place the sensor 180° from the valve stem.
7. Apply thread locker to the band clamp assembly screw threads. See
Figure 8
.
CAUTION: MAKE SURE THE BAND CLAMP ASSEMBLY IS COMPLETELY INSTALLED ON THE
WHEEL HUB AND DOES NOT MOVE OR SWAY.
8. Tighten the band clamp assembly on the wheel hub. See
Figure 9
.
9.
Torque the band clamp screw to 30-45 in-lbs (3.4-5.1 Nm).
10.
Cut off excess band if applicable.
11. Install the tire onto the wheel hub.
12.
Inflate the tire to the manufacturer's recommended pressure.
13. Use a balancing machine to balance the wheel with correction weights. An unbalanced wheel may
experience excessive vibrations at high speeds.
14.
Install the wheel on the vehicle per manufacturer's instructions.
© Pressure Systems International Inc.
All rights reserved worldwide.
20 T004-01 Rev 06-19