17
MAN 9066898 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70212626
6600 Vejen, Denmark
E-mail: [email protected]
WARNING
The machine may eject material that can cause serious eye damage if hit. Always wear
approved eye protection when using the machine.
Primer bulb
The primer bulb is used when starting a
cold engine: Press it 3 times (see Figure
5). Wait about 2 seconds between each
press.
Throttle
1.
For normal use, set the lever to FAST
to run the engine at full speed.
2.
Pull back the lever to reduce speed
and push it forward to increase
speed.
3.
To stop the engine, pull the lever all
the way back to the STOP position
(see Figure 6).
Starting the engine
1.
Move the throttle forward to START
or FAST.
2.
Check that the fuel cock is open
(button must be horizontal – see
Figure 7).
3.
When the engine is cold, press the
primer bulb three times. Wait two
seconds between each press.
4.
Grasp the starter handle firmly with
your right hand (see Figure 8).
5.
Pull slowly on the handle until you
feel resistance in the cord. Pull hard
so that the cord is pulled out to its
full length. Do not let the cord pull
back uncontrollably, but keep hold of
the handle as the cord slowly pulls
back.