3
MAN 9060917 EN V2
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70212626
6600 Vejen, Denmark
E-mail: [email protected]
Workplace
•
Keep the workplace free of flammable materials.
•
Always make sure there is a fire extinguisher within reach.
•
Only qualified persons may operate the equipment.
•
Ensure the workplace is clean, dry and well ventilated. Do not use the equipment in
humid, wet or poorly ventilated areas.
•
Ensure that the equipment is maintained by qualified technicians, cf. local and national
regulations.
•
Always exercise caution in relation to your surroundings. When welding, keep other
people at a safe distance, especially children.
•
Ensure that people in the area do not look directly at the welding arc.
•
Mount the welding apparatus on a safe bench or trolley and ensure that the
equipment cannot tip or fall over.
The condition of the equipment
•
Inspect the earth cable, power cable and welding cable to ensure that the insulation is
intact. Always replace or repair damaged elements before taking the welding
apparatus into use.
•
Inspect all of the elements to ensure that they are in a good condition before taking
the equipment into use.
Equipment use
WARNING
Never use the equipment if the cables, electrodes, welding torch, wire or wire feeder
are wet. Never lower the equipment in water – the above-mentioned elements and even the
equipment must always be dry before it is taken into use.
•
Follow the instructions in the manual.
•
Switch off the equipment when not in use.
•
Connect the earth cable as closely as possible to the site that is to be welded to ensure
a good earth connection.
•
Avoid poor working postures at all times. Ensure at all times that you are standing on a
safe and stable place when welding. Use the harness when working at heights.
