9
MAN 9035966 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70212626
6600 Vejen, Denmark
E-mail: [email protected]
Use
Filling with water
WARNING
The equipment may be damaged.
The pump must always be filled with water each time it is set up or in the
event of water loss or air intake. If the pump is run without water (dry
running), the pump will be destroyed.
1.
Unscrew the filter housing (6) and remove the filter insert.
2.
Fill up completely with water.
3.
Screw the filter housing back in. Check that the gasket is seated correctly.
4.
If filling time is to be shortened, fill the suction hose (can only be done with the check
valve).
5.
Open the discharge hose (open the water spout or tip) so that air can escape at the
inlet.
6.
Switch on the equipment.
7.
When water comes out in a steady stream, turn off the equipment.
NOTE
It is recommended to install a check valve between the pump and the suction
hose, so that the water cannot run out of the suction hose.
It is also recommended to use suction filters for better suction performance.
Operation
Connect pump and suction hose and fill with water.
WARNING
The equipment may be damaged.
The pump must not run dry.
WARNING
The equipment may be damaged.
Do not run the pump for more than 10 minutes with the discharge hose
closed. Running it longer can result in overheating and damage.