18
MAN 9063783 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70212626
6600 Vejen, Denmark
E-mail: [email protected]
Spark plug
Check the spark plug. It must be dry and
clean without deposits. Never attempt to
remove a spark plug from a hot engine,
as you may damage the thread.
Angular gear
Lubricate the angular gear with a single
shot of grease from a grease gun after
every 25 hours of operation.
Carburettor
The carburettor is set correctly at the factory and should not normally be adjusted.
Silencer
WARNING
The silencer must be checked periodically for loose joints, damage or
rust. If there are signs that the exhaust system has a leak, do not use the
machine until it has been repaired. Failure to do so may result in the
machine catching fire.
Air intake
If material becomes stuck and it blocks the air intake or becomes trapped between
the cooling fins the engine may overheat and damage the brushcutter.
(1)
Cooling ribs
(2)
Air intake
Therefore, before using the machine, check the cooling fins and air intake and remove
any dirt.