P.A. M63P, Руководство по обслуживанию

Страница: 3 / 28

2 3
@
Indicates a assembling/disassembling procedure.
I
Indicates a checking/maintenance operation on several parts.
M
Indicates suggestions/procedures to which particular attention should be given.
l
For disassembling and reassembling the snap rings (seeger) be careful not to force the
opening too much so that they do not lose their original shape. We advise using pliers with end
stop, if possible.
l
The STANDARD Tank cleaning head is supplied with seals (DYNAMIC) in PTFE + O-Ring in
EPDM. Lubricate ONLY with SILICONE GREASE P/N: 14.6552.00. For use with Detergent liquid,
Chemical addi tives etc that are not compatible with the standard seals, it is essential to
contact our TECHNI CAL OFFICE for further information. On request, the O-RING seals (DYNAMIC)
are available in different materials such as NBR-FFKM(kalrez)-FKM(viton). The STATIC seals
are in FKM (viton). For programmed maintenance check the instruction book under the heading “maintenance”.
l
When disassembling check that the gaskets, bearings and gears are intact and in good
condition. If an element is not perfectly intact and if it does not function properly request a
replacement from the manufacturer.
l
Always grease the ceramic coatings and the seal gaskets with silicon grease P/N: 14.6552.00
whilw assem bling.
l
Warnings page 3
l
General indications page 3
l
Disassembly/Checking page 6
l
Assembly/Maintenance page 14
l
Only qualified personnel should carry out the operations described in this ma-
nual.
l
For programmed maintenance check the instruction book under the heading “main-
tenance”.
Table of contents
Warnings
General indications
Used symbols