APEX V1 FOIL QUICK SET UP GUIDE
MAST
REAR WING
FUSELAGE
4x T30 28mm Custom Titanium Screws
4x Titanium T-Nut Deck Washers
(Supplied with Apex V1 board)
2x T30 **mm Custom Titanium screws
(**refer to table for screw length)
2x T30 **mm Custom Titanium screws
(**refer to table for screw length)
2x T30 22mm Custom Titanium Screws
2x T25 Custom Titanium Barrel Nuts
(fixed inside the Fuselage)
FRONT WING
2x T25 Custom Titanium
Barrel Nuts
(Fixed inside the Fuselage)
2x T30 Custom Titanium Barrel
Nuts (Fixed inside the Mast)
BY REMOVING THIS DOCUMENT AND
ASSEMBLING THIS PRODUCT YOU
ARE AGREEING TO THE FOLLOWING
TERMS AND CONDITIONS:
• The user understands that use of this product and
any of its components involves certain inherent
risks, dangers and hazards that can result in serious
injury and death.
• The user has read, fully understands, and agrees
to be bound by the terms of the Ozone product
manual including the Release of Liability, Claim
Waiver, Assumption of Risk Agreement, Warnings
and Safety Precautions.
• Any and all users of this product must fully
understand and agree to these terms.
IF YOU ARE UNWILLING TO BE BOUND BY THESE
TERMS, KEEP THIS DOCUMENT IN TACT AND RETURN
THIS PRODUCT (BEFORE USE) FOR A FULL REFUND.
IMPORTANT NOTES:
• Before assembling check all connecting surfaces, screws and barrel nuts are
clean and free of sand, salt or other debris.
• Only use original Ozone screws and barrel nuts. Damage and/or loss may occur
if using another type of screw.
• Do not tighten screws until all screws are in position and correctly threaded.
• Do not over tighten the screws, firmly hand tighten (approx. 8N.m torque
wrench setting) and release screws by hand only. Do not use power tools.
• The Fuselage barrel nuts are glued in place. These have a T25 head so the
supplied T30 tool cannot be used to mistakenly tighten or loosen. Do not
tighten or loosen the Fuselage barrel nuts, only tighten or loosen the screw.
If a Fuselage barrel nut becomes loose, use standard super glue to fix it back
into place.
• The Mast barrel nuts are glued in place. These have a T30 head so the supplied
T30 tool can be used to rotate the nuts to align with the screws if necessary. If a
Mast barrel nut becomes loose, use standard super glue to fix it back into place.
• The Fuselage to Mast connection is designed to be a tight fit. Align the screws,
get them started and proceed to tighten. Approximately the last 2mm of Mast
tuttle section will be pulled into the Fuselage by tightening the screws. The
connection will then become flush.
• If stored set up, before each use check the screws and parts are fitting tight,
retighten screws if necessary.
